Electronics Forum | Fri Jan 29 10:53:13 EST 2010 | jeffharley
There are pots on the board in the power supply to adjust the voltages after the machine is powered up. The location of these pots are in the munual supplied with the machine
Electronics Forum | Tue Apr 30 10:03:31 EDT 2013 | mmjm_1099
Got it powered back on Friday.... We did check the UPS (power-supply)and indeed it was bad. So we referenced the manual and found you can bypass the UPS all together. So we just directly plugged the machine past the UPS. Well the machine is running b
Electronics Forum | Mon Apr 29 00:29:11 EDT 2013 | aemery
If you have a UPS on your machine there should be auxiliary contacts in the main breaker switch SW 1. These contacts tell the UPS if the main rotatary switch in turned to on or off. If the rotary switch was set to off the UPS knows not to turn on i
Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Wed Sep 19 10:34:44 EDT 2018 | sarason
Now I have to guess and make a few assumptions. Without looking at the back side of the board my guess is you have some 400-100V diode bridges before the resistor ,zener and the FET . The FET is a 500V 0.85 Rdson NFET. All of this suggests a chopper
Electronics Forum | Thu Apr 30 09:27:58 EDT 2020 | clockwatcher
I currently have a board that has several wires that need to be soldered into it. Many years ago I remember wave soldering power supply boards that also had many wires. In order to keep the wire insulation out of the solder fillet and keep the wires
Electronics Forum | Mon Apr 29 05:25:13 EDT 2002 | ianchan
Hi, we do Sn plated I/O pinning insertion into Ni/Au thru' holes. no problems here so far, as we cater for the "interference" (fit-allowances) of the I/O pin into the thru' diameter, via improved PCB thru' hole designs. before this cater/considerati
Electronics Forum | Sat May 03 13:56:12 EDT 2014 | jyo_409
We are using TL431 in our most of the power supply circuits. Recently the power supply board is returning from the field due to TL431 component problem. Could you people, please suggest me what are the possible reasons for TL431 failure & trouble sho
Electronics Forum | Sun Nov 22 17:52:49 EST 2015 | wesleyintelli
Hi Deni, Thanks for your interest in my problem. It turned out that the power supply to the VGA vision board (the system in the black box)was faulty. I replaced it with a universal PC power supply and all is well.
Electronics Forum | Thu Aug 06 20:08:35 EDT 2015 | edwaterfall01
It could be a blown fuse on the power distribution panel or a failed power supply. Check the power distribution board in the front lower center of the machine. There are 11 LEDs on the board and 10 should be ON