Electronics Forum | Wed Nov 13 16:48:19 EST 2013 | spoiltforchoice
I would expect any half decent machine to place 0603 parts slap bang on target to the typical defined accuracy for such parts on most machines of perhaps ~60 microns or better. Self correction during reflow is IMHO much less pronounced with lead-free
Electronics Forum | Tue Nov 12 17:11:32 EST 2013 | mondalaci
Hi Folks, I'm working on a LED display that is composed of multiple layers. What is interesting for the point of this discussion is the PCB layer and the light deflector layer on top of it. Please take a look at the related pictures at http://plus
Electronics Forum | Sat Mar 20 00:14:54 EDT 2021 | cbeneat
This is the model we have. The x-ray parts counter is from Optical Control and is a model OC-SCAN CCX.3 A.
Electronics Forum | Tue Aug 23 03:29:37 EDT 2022 | samhe
I received a buck-boost DCDC board with an optical sensor from NextPCB, so I mounted the components and measured the efficiency. Table of contents Board received from NextPCB Solder paste printing Mounting of parts Reflow operation check Attaching
Electronics Forum | Sun Mar 04 01:56:37 EST 2012 | eadthem
What we have had recently is a lot of larger thin (32 thou) thickness boards that have had issues with SC90 diodes bouncing off the pads in the final PNP machine. Our setup, universal instruments GC120 or quad beam 30 spindle lightning heads. This m
Electronics Forum | Thu Dec 21 13:11:25 EST 2006 | SWAG
We have fought with cut-tape way too much. It's always a bad idea. We've tried a couple methods/devices for manual splice with limited success. Before you look into this I would ask them if they could supply you cut tape qty's inslusive of fairly
Electronics Forum | Fri Aug 24 14:56:11 EDT 2001 | Hussman
Paul, All the machines yulisted are very god at placement. One thing to keep in mind is parts availability. Some of our jobs come from the customer in "kits". Not everyone supplies you with a full real of parts. Be sure that the machine you pick
Electronics Forum | Tue Aug 21 08:34:03 EDT 2007 | rgduval
We have the same problems with cut/tape parts. But, we specialize in short-run prototypes, so I don't have much of a choice but to deal with it, and find a way to make it as easy as possible. We just demo'd a splice tool from Sierra Electronics (ww
Electronics Forum | Thu May 30 10:31:03 EDT 2002 | robbied
Hi Yannick. This is an issue that we are just recently getting into but here is some ifo that I have gathered so far. I have seen/ used 2 different rework machines. The one we have bought is a 'PACE TF2000' which was at the lower cost end of the mar
Electronics Forum | Thu Nov 07 08:27:13 EST 2002 | davef
Yeh, that RIPPPPP sound that seperating velcro makes is a real hint isn't it. Use your field meter to confirm your suspicions. We cut the straps.
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
