Electronics Forum | Tue Aug 10 16:57:29 EDT 1999 | JohnW
| | Does anyone use reflow profilers? Are they a good investement or is trial and error sufficient? | | | | Does anyone have any suggestions on profiles to try? Thanks. | | | Danielm | I would hazard a guess that most if not all of us production f
Electronics Forum | Fri Sep 17 15:15:10 EDT 1999 | Dave F
snip | | So Ryan have we just gotten back from lunch with someone? | | Yes, and for a rookie, it was mildly confusing. I'm as of recent, a regular "reader" of the forum and thought it might be (and it is!!!) a good place to get other opinions. |
Electronics Forum | Thu Sep 16 11:04:48 EDT 1999 | Lee Radney
Looking for Computerized Maintenance Software..... Here is what we need.... We are a high volume, high mix, company with 3 independent lines. All support personnel have pagers. We are looking for a piece of software that can handle daily maintenanc
Electronics Forum | Thu Aug 27 17:40:11 EDT 1998 | Earl Moon
| Does anyone have any experience they are willing to share on Ag epoxy used as a copper through hole plating replacement? Was CEM3 used? | What are the limitations? | Thanks, | Steve Steve, Hello again. Hope you guys (Intel) aren't going to do that
Electronics Forum | Wed Jan 16 20:06:09 EST 2002 | davef
No, not as such. Consider: * Using the IPC calculator [free at http://www.ipc.org]. It allows you to consider / assess the amount of solder when designing pads. * Reviewing IPC-7525 - Stencil Design Guidelines. It gives general aperture guidelines.
Electronics Forum | Thu Oct 31 08:02:12 EST 2002 | davidweir
we are looking at buying an screen printer and are curretly have an mpm up1500 and dek ela on the shortlist both silimar spec's except mpm has automatic tooling. being a cem having to change set up a number of time a week quick change over is a co
Electronics Forum | Tue Mar 04 10:50:25 EST 2003 | ggspook
Hi Mike Interested on your thoughts about (Pam) Placement Accuracy Measurement I am looking into establishing Accurate repeatability of my equipment we check our calibrations Regular and the calibrations are in spec but this does not guarantee
Electronics Forum | Wed Apr 16 08:51:10 EDT 2003 | russ
You don't need to guess at belt speed, for example if your oven (heating area) is fifteen feet long, run at 1 ft./min that will be 15min total process time. As far as temp profiling you need to run T/C because each oven is different even if it is th
Electronics Forum | Fri Aug 20 11:34:11 EDT 2004 | soease
Hi Grant, sly again. I was searching for some infos about Auto-SIR, and I found something that may interrest you; Concoat, wich is the company who sells Auto-SIR systems, also has profiling tools and they seem to have a more powerful software to ana
Electronics Forum | Wed Jan 12 09:19:06 EST 2005 | Scott B
If you go into 'Magazine' menu and select 'Hydra preparation' then select the layout you wish to optimise (thats the stinger, you can only optimise for a single layout). You will then be presented with optimisation options which can be adjusted ('sa
