Electronics Forum | Tue May 07 10:32:13 EDT 2002 | Todd M. Troyer
Does any one know where I can get after-market preheaters for an Electrovert Econopak II SMT wave?
Electronics Forum | Todd M. Troyer |
Tue May 07 10:27:13 EDT 2002
Electronics Forum | Tue May 07 11:28:41 EDT 2002 | pjc
Specnor Tecnic- Canada www.specnor.com
Electronics Forum | Tue May 07 10:52:59 EDT 2002 | fastek
Call Vicki Moore at TND Service Inc. (603) 437-4755. They service and support older Electrovert waves. They will be able to help you out. Rick
Electronics Forum | Mon May 13 10:28:41 EDT 2002 | leboeuf
Todd, We have used and aftermarket pre's in stock. Call Kerry at 603-669-6080 x351. Steven
Electronics Forum | Sat Jun 24 10:10:31 EDT 2017 | fugtussey
Here's a good IR preheater that you should look at: www.paceworldwide.com/products/smt-rework-systems-and-preheaters/preheaters/ph-100-low-profile-pcb-preheater
Electronics Forum | Tue Sep 15 10:19:23 EDT 1998 | dave c
| Dave, | How thick are your PCBs? Do you have adequate topside preheat or are the bottom preheaters turned up to ensure proper filleting on the top side? | Rob Rob, The average PCB is .062". There is no topside preheaters on our machine
Electronics Forum | Wed Jul 10 16:34:23 EDT 2013 | hegemon
Preheating is critical in Vapor Phase Soldering. One trick that is done is to use the "soft vapor" area just above the soldering vapor, some machines can pause just before going into the soldering vapor. Using that pause above the vapor to continue
Electronics Forum | Wed Feb 25 21:37:12 EST 2015 | dinhhuunam
Hi Bartel , 1.1 Profile Solution to Cold Soldering Cause for Cold soldering The peak temp of reflow is too low. The preheating temp is too high and it takes too long Solution Lower the preheating temp and increase the peak temp in the reflow zone
Electronics Forum | Mon Nov 26 20:41:24 EST 2001 | davef
Which ramp is this? * Ramp to preheat? * Preheat? * Ramp to spike?
