Electronics Forum | Mon Oct 25 16:53:57 EDT 1999 | Mario
Hi, Does anybody know where I could get a cheap but efficient press for press fit connectors (200pins and up)? Pneumatic or Hand lever Mario
Electronics Forum | Tue May 28 11:36:46 EDT 2002 | floydl
Hello Jim, Is any special tooling required for press-fitting a connector?
Electronics Forum | Tue May 28 16:19:52 EDT 2002 | zanolli
Hello Floyd, Yes, special tooling is required. The tooling usually consists of a press, push-in tooling and support plate tooling. The presses can range from relatively simple arbor type presses to automated hydraulic presses with sophisticated con
Electronics Forum | Tue Oct 26 10:23:58 EDT 1999 | Arthur
Mario You can reach ASG at PH: 561-848-6746
Electronics Forum | Mon Oct 25 17:06:18 EDT 1999 | William
Mario, If you are looking for a cheap press to do press fit connectors, then you are asking for trouble. Now, and in the long run. ASG out of West Palm Beach makes a very good press. We bought a 5 ton version and are able to press up to about 2500
Electronics Forum | Mon Oct 25 19:29:12 EDT 1999 | g cronin
hi mario there is a company called motion automated that makes a nifty press, i have one in my shop that i have used for a while. well built and they have been able to make me custom tooling as well at reasonable prices. i'm going to try to dig u
Electronics Forum | Thu Apr 18 14:00:35 EDT 2002 | Romain
Is anyone has experience on problems with press-fit on Ni/Au board finish. Connectors pins are SnPb finished. I am particulary interested by experiences or documentation in very agressive environmental conditions (avionics or space buisness) Thanks r
Electronics Forum | Mon Apr 29 05:25:13 EDT 2002 | ianchan
Hi, we do Sn plated I/O pinning insertion into Ni/Au thru' holes. no problems here so far, as we cater for the "interference" (fit-allowances) of the I/O pin into the thru' diameter, via improved PCB thru' hole designs. before this cater/considerati
Electronics Forum | Tue Oct 14 08:27:32 EDT 2014 | kkay
We use a few different style of press fit connectors, terminals, studs, etc. We use a tabletop arbor press for most everything we do, but a lot of times we will see some measling or slight delamination around the holes for the press fit part. Is ther
Electronics Forum | Tue Nov 05 00:53:31 EST 2002 | YNgwie
How do we do press fit component rework ? I have connectors with 700 pins, and the rework part is a headache. What is the best method ? Thanks in advance.
winsouce.jpg)