Electronics Forum | Mon Apr 29 05:25:13 EDT 2002 | ianchan
Hi, we do Sn plated I/O pinning insertion into Ni/Au thru' holes. no problems here so far, as we cater for the "interference" (fit-allowances) of the I/O pin into the thru' diameter, via improved PCB thru' hole designs. before this cater/considerati
Electronics Forum | Tue May 28 13:14:31 EDT 2002 | zanolli
Hello Mark, I'll assume that you are currently wave soldering and would like to eliminate that operation by using pre-forms or press-fit connectors. Solder preforms or solder flux bearing connector leads usually do not require any hole size changes,
Electronics Forum | Tue Dec 17 13:42:04 EST 2002 | robf
There are a few emerging technologies that have been growing in popularity for the past few years. Pin through paste, press fit connectors and selective soldering machines seem to be displacing custom fixtures. Most of the mixed technology boards o
Electronics Forum | Tue Mar 13 08:04:28 EDT 2007 | Cmiller
We have used thousands of them with no problems. They will not aid in "connector retention" unless you have a shear force at exactly the right angle. This is an advertising joke. They will help with alignment of the connector. Open your holes up so t
Electronics Forum | Sat Sep 11 10:51:59 EDT 1999 | JohnW
Folk's, Been asked / told by my boss to look into our board prepping area for wave soldering and find another way of doing it. Thing's I'm looking at are: PCB Breakout - do you do it before or after wave Connector's that need to be pressed in due to
Electronics Forum | Mon Mar 08 10:02:11 EST 1999 | Steve Beck
Hello; I am looking for general info on backplane assemblies. Any info would be appreciated, but some of the questions that come to mind include: -What part types other than connectors do backplane cards have on them? SMT? Leaded? Quantity? Is
Electronics Forum | Fri Apr 08 05:10:10 EDT 2005 | siverts
What is Your customers requirements? Is the PCBA mounted with front/back connectors? Will the PCBA be mounded in a rack and connected to opposite connectors on the other side? In this case, if the warpage is more than approx 1-1.5 % You will then n
Electronics Forum | Mon Mar 08 10:44:07 EST 1999 | Matt Stackhouse
| Hello; | | I am looking for general info on backplane assemblies. Any info would be appreciated, but some of the questions that come to mind include: | | -What part types other than connectors do backplane cards have on them? SMT? Leaded? Qua
Electronics Forum | Mon Mar 08 11:46:38 EST 1999 | Wendy Casker
| Hello; | | I am looking for general info on backplane assemblies. Any info would be appreciated, but some of the questions that come to mind include: | | -What part types other than connectors do backplane cards have on them? SMT? Leaded? Qua
Electronics Forum | Mon Jul 30 16:26:45 EDT 2012 | rdouglass
Just curious if anyone else has trouble with the installation and inspection of DIMM Connectors (I know - these are through-hole parts!) We have boards with 240 pin DIMM connectors and occasionally a pin may not be properly aligned prior to press-f
