Electronics Forum | Mon Oct 25 16:53:57 EDT 1999 | Mario
Hi, Does anybody know where I could get a cheap but efficient press for press fit connectors (200pins and up)? Pneumatic or Hand lever Mario
Electronics Forum | Mon Apr 29 05:25:13 EDT 2002 | ianchan
Hi, we do Sn plated I/O pinning insertion into Ni/Au thru' holes. no problems here so far, as we cater for the "interference" (fit-allowances) of the I/O pin into the thru' diameter, via improved PCB thru' hole designs. before this cater/considerati
Electronics Forum | Thu Apr 18 14:00:35 EDT 2002 | Romain
Is anyone has experience on problems with press-fit on Ni/Au board finish. Connectors pins are SnPb finished. I am particulary interested by experiences or documentation in very agressive environmental conditions (avionics or space buisness) Thanks r
Electronics Forum | Thu Apr 18 16:52:15 EDT 2002 | davef
General comments are: * First place I would look is the supplier of the pins that you are trying to install. Most suppliers that sell press fit components have done a good deal of work to qualify the component and will have all the specifications yo
Electronics Forum | Mon Oct 25 17:06:18 EDT 1999 | William
Mario, If you are looking for a cheap press to do press fit connectors, then you are asking for trouble. Now, and in the long run. ASG out of West Palm Beach makes a very good press. We bought a 5 ton version and are able to press up to about 2500
Electronics Forum | Tue May 28 16:19:52 EDT 2002 | zanolli
Hello Floyd, Yes, special tooling is required. The tooling usually consists of a press, push-in tooling and support plate tooling. The presses can range from relatively simple arbor type presses to automated hydraulic presses with sophisticated con
Electronics Forum | Tue Oct 14 10:21:44 EDT 2014 | fredc
Accuracy of the arbor press might be made better by tightening the adjustable gibs on the ram if any. If you can use support under the board have the ID of the support just slightly larger than the pins being pressed. Janesville Tool makes an accura
Electronics Forum | Tue Nov 05 00:53:31 EST 2002 | YNgwie
How do we do press fit component rework ? I have connectors with 700 pins, and the rework part is a headache. What is the best method ? Thanks in advance.
Electronics Forum | Wed Feb 09 12:02:15 EST 2000 | Wolfgang Busko
Sal: If it�s not the PCB, what about the connector itself ? Is it from a different production lot with some unregularities ( dimensions, tolerances, pin alignment, material weakness)? How about handling, storage, shipping causes ? Could it be a tooli
Electronics Forum | Wed Feb 09 10:20:26 EST 2000 | Sal
Currently we have started seeing an issue around a scuzzy connector.The problem being that during insertion of this connnector a couple of pins refused to be inserted and as a result fold over, this folding of the pin is causing the pin itself to fra
