Electronics Forum | Wed Jul 15 15:35:21 EDT 1998 | Michael Fogel
Hello Mark, Here in ECI, because the nature of our products, are using the method of press fit connectors in big numbers and although we have SMT components (around 200 per board) as well as T/H components we still preferred to use press fit because
Electronics Forum | Tue Nov 07 09:26:37 EST 2000 | Peter Barton
Adam, The most common cause for this problem is a variation in the plating thickness of the through holes, particularly if they are Sn/Pb solder levelled PCB's. Most pressfit connectors require a fairly tight control on the diameter of the holes to
Electronics Forum | Sun Nov 10 15:36:06 EST 2013 | davef
Assuming your conformal coating material was selected with the intent of living a life in contact with oil, why doesn't your coating meet the IPC-A-610D requirement of that there be no voiding, no breaks in the surface, no loss of adhesion, etc? Furt
Electronics Forum | Tue Dec 17 13:42:04 EST 2002 | robf
There are a few emerging technologies that have been growing in popularity for the past few years. Pin through paste, press fit connectors and selective soldering machines seem to be displacing custom fixtures. Most of the mixed technology boards o
Electronics Forum | Mon Jul 30 16:26:45 EDT 2012 | rdouglass
Just curious if anyone else has trouble with the installation and inspection of DIMM Connectors (I know - these are through-hole parts!) We have boards with 240 pin DIMM connectors and occasionally a pin may not be properly aligned prior to press-f
Electronics Forum | Tue Nov 07 11:14:11 EST 2000 | Adam
There is a variation on the pins that come through on the other side. The pins that are deforming are roughly half the size of those which aren't deformed.There are no witness marks on the pins that are deformed, suggesting that the pins aren't fouli
Electronics Forum | Tue Sep 01 15:37:25 EDT 1998 | Ben Salisbury
| How would you mount a surface mount chip onto Perf board? I am doing a project for school and one of the chips is a surface mount, but everything else fits in Perf board. Any suggestions? Thanks Matt- Find some fairly stiff wire, the correct gau
Electronics Forum | Thu Feb 27 17:24:34 EST 2003 | pauld
Forgive the non-SMT question. That's why I hate through hole boards. Has anyone ever used Bareco wax on pressfit connectors, and how do you produce a consistent process for its application? Any drawbacks? Background: We have found a design issue with
Electronics Forum | Thu Jul 20 14:52:05 EDT 2000 | Bob Willis
If you are talking about Pin In Hole Reflow that is not true, I hope it was not my friends at Speedline that told you that. Stencil printing of paste for through hole reflow can be done. If you get all the parameters right it can give you joints lik
Electronics Forum | Wed Oct 06 08:49:22 EDT 1999 | Mark
| | I hope that someone can help me with my problem! I am experiencing a lot of glued on parts falling off in the wave solder machine. A little information about my process: 1)We use Loctite 3609 glue that is used up long before its shelf life 2)Ou