Electronics Forum | Tue May 28 11:36:46 EDT 2002 | floydl
Hello Jim, Is any special tooling required for press-fitting a connector?
Electronics Forum | Mon Jan 22 03:51:16 EST 2007 | Bing
We are using HASL board for Press Fit, without problem in the past until recently. Now we are seeing the solder in the PTH melt and block partially the PTH hole during the reflow. It gives problem when Press Fit. Anyone has advice on this?
Electronics Forum | Tue Oct 14 08:27:32 EDT 2014 | kkay
We use a few different style of press fit connectors, terminals, studs, etc. We use a tabletop arbor press for most everything we do, but a lot of times we will see some measling or slight delamination around the holes for the press fit part. Is ther
Electronics Forum | Mon Jan 22 09:35:34 EST 2007 | saaitk
Check that your boards haven't been over plated. Too much plating in the hole can slump to the underside of the board during reflow. If you are then press fitting on the underside of the board you can have problems with hole diameter. If the hole is
Electronics Forum | Tue Jul 14 13:47:53 EDT 1998 | Mark Barnett
There's a battle brewing around here regarding the use of press fit connectors in place of their thru hole counterparts because of suuposedly better reliability. Is there any validity to this statement? Up until now, we have only been going with pr
Electronics Forum | Wed May 16 14:09:22 EDT 2001 | davef
First thing I'd use is IPC-A-610C, �4.8.2 Connector Pins - Press-Fit Pins. Does it work in your case?
Electronics Forum | Mon Oct 25 16:53:57 EDT 1999 | Mario
Hi, Does anybody know where I could get a cheap but efficient press for press fit connectors (200pins and up)? Pneumatic or Hand lever Mario
Electronics Forum | Thu Apr 18 14:00:35 EDT 2002 | Romain
Is anyone has experience on problems with press-fit on Ni/Au board finish. Connectors pins are SnPb finished. I am particulary interested by experiences or documentation in very agressive environmental conditions (avionics or space buisness) Thanks r
Electronics Forum | Fri Oct 11 13:47:48 EDT 2002 | mnaddra
Does anyone know of automated equipment makes and models for auto inserting press fit connectors in to backplanes. Mike
Electronics Forum | Tue Nov 05 00:53:31 EST 2002 | YNgwie
How do we do press fit component rework ? I have connectors with 700 pins, and the rework part is a headache. What is the best method ? Thanks in advance.
