Electronics Forum | Wed Apr 28 10:29:04 EDT 2004 | dougt
By "placement pressure" I assume you mean force. I don't know of placement machines that have transducers mounted on the placement spindles that actually measure force. We made a board with a force sensor mounted through a hole so that it was the sa
Electronics Forum | Thu Apr 29 10:35:31 EDT 2004 | dougt
Start with a load cell (force sensor), you will need one that can handle the force range you will be placing. Someone please correct me on this if I'm wrong but I seem to recall that placement force runs in the range of a couple hundred grams. Chec
Electronics Forum | Mon Apr 16 15:28:10 EDT 2018 | emeto
If you have pressure sensors in there(most contemporary machines have), value is probably right. It doesn't mean though that the value is correct(see the upper post)
Electronics Forum | Fri Jul 01 07:19:12 EDT 2016 | sachinverma
Dear sir, how check the pressure sensor its software baseed.
Electronics Forum | Tue Aug 03 06:14:18 EDT 2021 | bukas
if blade swapping gives same result try swapping the pressure sensors.
Electronics Forum | Fri Dec 26 23:05:29 EST 2003 | tommy
It can be wrong pressure sensor switch setting,malfunction or low incoming air pressure.If incoming air pressure below the setting limit then 1 block stop message will display on screen.
Electronics Forum | Sat Dec 27 13:55:13 EST 2003 | fpcb
I put a short-circuit to pressure sensor input AD but the problem remains.
Electronics Forum | Sat Dec 27 13:56:00 EST 2003 | fpcb
I put a short-circuit to pressure sensor input AD but the problem remains.
Electronics Forum | Thu Jun 23 15:20:49 EDT 2016 | caurbach
Could be a partially clogged nozzle. Try disassembling the nozzle and thoroughly cleaning it. If that doesn't fix it, see if there are any blockages in your plumbing. If you can't find any blockages, it could be your pressure sensor.
Electronics Forum | Fri Dec 27 13:16:18 EST 2019 | slthomas
Can you describe the failure mode of the soldering defect, i.e., is it failing to meet the height requirement for a castellated termination due to not wetting of the component terminations, or not wetting the pads sufficiently, or....? We install a
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
.gif)
