Electronics Forum | Mon Nov 11 21:19:06 EST 2019 | dekhead
Knead pressure, is normally at or slightly lower (maybe 25%) than print pressure...
Electronics Forum | Thu Aug 27 03:19:21 EDT 2020 | dekhead
Have you done Squeegee Heights calibration? (no tools required) Does it complete cal routine without error? Does pressure compensate on next print, with corresponding squeegee, following acknowledgement of pressure error? The readings calibration, ge
Electronics Forum | Thu Apr 12 08:14:43 EDT 2018 | cyber_wolf
The way to determine correct pressure (in my experience) is to start out at what you would consider to be a low sq. pressure setting. You are looking for it to leave a slight film of paste on the stencil. Start increasing pressure in small incremen
Electronics Forum | Wed Nov 06 06:34:26 EST 2019 | kylehunter
We have a DEK HORIZON 265 that seems to be having an issue with the pressure setting for the squeeges. It seems to have an override making the set point of the squeege pressure always be 5kg. I have it set to 12kg, but on the first print, it errors
Electronics Forum | Mon Nov 11 20:26:37 EST 2019 | kylehunter
Alrighty... Problem solved - ended up not being a problem at all. So, what I didn't realize, was that the knead pressure was 5kg, and the first print was always kneaded, so that's why the set pressure showed 5kg. After it was done kneading, the set
Electronics Forum | Wed Oct 02 13:59:11 EDT 2002 | davef
There are some excellent exhumation structures of high pressure and superhigh pressure metamorphic terranes in the Qinling-Dabie Mountain belt.
Electronics Forum | Fri May 21 03:01:22 EDT 2004 | Nitro
I want to know the pressure of N2 in each zone in furnace. If have standard it will better.
Electronics Forum | Wed Sep 01 06:38:37 EDT 2010 | grahamcooper22
Dear Leeg, Generally the faster your print speed the more down pressure you need on the blade to roll the paste and wipe the stencil surface clean. Pastes with higher viscosity need more pressure at slow and high print speeds. Too much pressure cause
Electronics Forum | Wed Nov 06 06:46:27 EST 2019 | wippsen
Machine Calibration --> Pressure
Electronics Forum | Wed Apr 13 21:04:39 EDT 2005 | pdeuel
We have a controlled pressure facility. When the pressure is set at 0.2 lbs above outside our security doors that open outward do not close by themselvs causing alarms. Our facility remains dusty under and on equipment because of conditions listed on
