Electronics Forum | Tue Mar 20 18:28:26 EDT 2018 | dekhead
Print Head Stroke Calibration?
Electronics Forum | Wed Mar 21 14:58:23 EDT 2018 | edjeske
Thank you for your response. I appreciate all anyone can provide to help with this. I have no manuals to use. I inherited this task when the usual operator dropped dead the other day. He was the only one who ever ran this machine. I was able to print
Electronics Forum | Tue Mar 29 03:03:42 EDT 2016 | wesleyintelli
Our MPM UP100 is not slowing the pcb carriage as it is brought under the stencil. The result is that the carriage jolts the machine heavily when it is fully loaded. The hall effect vane sensor half way along the rear rail is working correctly. The le
Electronics Forum | Thu Mar 30 10:02:03 EDT 2017 | Bestglobal SMT
We have a 2008 DEK horizon 03i this machine has been a very reliable system. we are having an issue with the print being offset in the x .2mm I have run 4 different boards - same issue on all. same offset. i can print the board 10 times over and
Electronics Forum | Thu Mar 30 10:54:48 EDT 2017 | emeto
If you use the calibration plate and stencil, that should fix the problem. I think that you are not saving the result from the calibration test. Double check manuals and probably with DEK technician, but it sounds like you are missing a step.
Electronics Forum | Mon Mar 24 14:19:36 EDT 2008 | burb1999
I have a DEK ELA and here is what happens. I print a board after going through the step and it is a dead on print. Then, with another print it will be off in Auto mode (sometimes up and sometimes down, seems to just be up and down not left to right
Electronics Forum | Tue Jun 25 21:13:10 EDT 2024 | jeremyc
I also happen to be running into this issue. A PCB we're trying to program has a width larger than the max board width. On our O2i, it says 12.992in is the max board width. HOWEVER the tech specs of Dek Horizon O2i advertise a max print area of 508m
Electronics Forum | Wed Mar 26 09:26:12 EDT 2008 | lloyd
I know you said you checked your clamps but another look will do no harm. we had a very similar issue a while back, and it turned out that the plastic shim under the chase clamp magnet was damaged. This caused the chase clamps not to release properly
Electronics Forum | Tue Jun 19 16:19:34 EDT 2007 | bk
There are no batteries in mydata magazines. This problem means your voltage is outside it's allowed range. In this case I think it's the 15 volts. If you open up the bottom of the machine and pull out the carriage you'll see a rectangular box that ho
Electronics Forum | Tue Dec 23 17:34:07 EST 2008 | davef
We hear you talking two main issues: 1 Solder paste release 2 Thoughts on using two passes of solder paste on the stencil 1 Solder paste release * Check your aperture & aspect ratios [Search the fine SMTnet Archives for more] * Do a better job with
