Electronics Forum | Wed Feb 22 16:55:04 EST 2006 | mark
Hi, We are not using vaccum caps. The support pins for both printers is the same ande cover all board (components only on Top side of the PCB). I will check snap-off (right know setting 0.2-04. mm/s). I also suspected poor gasketing but clamps are o
Electronics Forum | Tue Jun 25 21:13:10 EDT 2024 | jeremyc
I also happen to be running into this issue. A PCB we're trying to program has a width larger than the max board width. On our O2i, it says 12.992in is the max board width. HOWEVER the tech specs of Dek Horizon O2i advertise a max print area of 508m
Electronics Forum | Thu Mar 19 12:26:10 EDT 2020 | yuaanliie
You have mostly set in your mind before purchasing PCB i.e. PCB is an acronym for the printed circuit board. Last month I purchased PCB from Great PCB.
Electronics Forum | Tue Apr 09 16:19:37 EDT 2002 | Peter L.
Has anyone built using the ALIVH PCB (0402, 0.8mm pitch uBGA) on the SMT line? I would like to know any process issues (paste printing, p&p, reflow) related to processing this pcb. Specifically, what type of solder paste was used (no clean) and wha
Electronics Forum | Mon Jun 03 12:08:10 EDT 2019 | slthomas
Are you designing just the stencil, or are you designing the pcb too?
Electronics Forum | Wed May 22 08:45:51 EDT 2019 | directx995
You can always ask your component supplier for datasheet of specific coomponent. If component is developed specificly then part of datasheet (PCB layout recommendation). Best Regards
Electronics Forum | Mon Jun 03 15:10:48 EDT 2019 | emeto
Page 43 in the datasheet is giving you all detail how the stencil should look like...if this is what you need to do. Page 42-43 shows the geometry of the part and recommended land pattern for the PCB ...if this is what you need.
Electronics Forum | Sat Aug 05 09:03:33 EDT 2006 | davef
Start here: http://en.wikipedia.org/wiki/Printed_circuit_board
Electronics Forum | Tue Apr 09 18:29:34 EDT 2002 | davef
Any-Layer Interstitial Via Hole (ALIVH). In printed circuit board fabrication, a registered mark of Matsushita Electric for a filled microvia structure in all layers for applications requiring small-size, lightweight build-up PWB to achieve high-den
Electronics Forum | Thu Jul 27 18:47:52 EDT 2006 | rogerw_tech
what machines do I need to satart a hi-tech printed circuit board production line with upto 16 layers?
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
