Electronics Forum | Thu Mar 30 10:54:48 EDT 2017 | emeto
If you use the calibration plate and stencil, that should fix the problem. I think that you are not saving the result from the calibration test. Double check manuals and probably with DEK technician, but it sounds like you are missing a step.
Electronics Forum | Thu Mar 30 10:02:03 EDT 2017 | Bestglobal SMT
We have a 2008 DEK horizon 03i this machine has been a very reliable system. we are having an issue with the print being offset in the x .2mm I have run 4 different boards - same issue on all. same offset. i can print the board 10 times over and
Electronics Forum | Tue Apr 06 09:44:05 EDT 2021 | vasu278
Iam getting cpu hanging issues for accuflex printer but machine is running ok.can i install the software and drivers to another cpu which has different motherboard will work or any problems occur, if doesn't work can i reconnect old cpu and can i abl
Electronics Forum | Fri Apr 21 22:47:39 EDT 2006 | fastek
SMEMA didn't exist when this printer was in production.....at least not in the early years of production.
Electronics Forum | Fri Apr 21 16:55:16 EDT 2006 | Geo E
I am trying to find out if the AP20 MPM Printer is SMEMA ready or was it an Add-on, I can not find any documentation in the manual as to where the Smema is to be connected.Or does the diagrams show any smema hook ups. Any help would be appreciated.
Electronics Forum | Fri Apr 21 23:13:59 EDT 2006 | valuems
The snema connecters are located behind the front cover, and to the left of the small power supply. The connecters are up side down. The front one is the left side and the second one back id the right side. Left is normaly the upstream and the rig
Electronics Forum | Wed Aug 31 09:45:36 EDT 2016 | ttheis
I have a smema conveyor connected to the downline fmi connection on my up500 but the fmi sugnals show the coneyor ready signal going ro the upline ready input (screenshot). The downline ready output is activated qhen a board is output from the printe
Electronics Forum | Wed Sep 07 16:36:18 EDT 2016 | ttheis
It does look like it was setup for fuji or siemens connection. I did get the smema signals working; had to add the connections for pins 3 & 4 on both ports and move some of the existing connections according to the smema diagram. Also, I wasn't seein
Electronics Forum | Fri Oct 31 14:09:07 EDT 2014 | wbrenner
Having a problem with a DEK printer. In the back to front motion, getting poor ramdom paste volume on micro BGA pads. Other BGA 1 mm pads are fine. The front to back motion is fine. Any throufghts on this directional issue. Ran ~200 panels no pr
Electronics Forum | Thu Jul 07 11:52:25 EDT 2016 | proceng1
We just pulled a Speedline Accuflex printer out of storage. After programming a board and stencil, and calibrating the fiducials and everything, we do a test alignment and bring the board to print height. It is off. I've done it now with two diffe
