Electronics Forum | Thu Oct 06 08:55:05 EDT 2005 | stepheniii
If a rubber squeege is bumped on the edge, no biggee. But you have to be carefull the metal ones don't get dinged. All it takes is a little extra care but if your operators are used to handling the rubber one they might not increase the amount of c
Electronics Forum | Thu Oct 06 09:12:54 EDT 2005 | russ
in addition, your prints may have a larger volume from the reduction of scooping from the rubber blades.
Electronics Forum | Thu Oct 06 07:28:11 EDT 2005 | chunks
The obvious is size. Besides that, it depends on your screen printer. Some "smart heads" need to be retaught with the metal blades for each board. Some need to have the set-up programmed changed too. Angle of attack is something to double check a
Electronics Forum | Thu Feb 12 20:36:26 EST 1998 | Jon Medernach
| Using metal squeegees on GSPs has caused premature stencil wear. Has | anyone had any success with this combination? How much snap off did you | use? We are using .5 mm pitch and have a no clean process. Stencil wear is is minimal but exists. T
Electronics Forum | Wed Feb 03 09:34:43 EST 2016 | oxygensmd
He everyone, We have an Ekra E5 screen printer which is really nice machine I think. Now I'm looking forward a new squeegees set. I don't know the E-series and the X-series can use both squeegees? Are the squeegee holder the same on this two machin
Electronics Forum | Fri Feb 20 14:16:06 EST 1998 | Dave McFadyen
I've been using metal blades on several brands of printers over the past few years and have to agree with comments in other replies. Contact print is a must or you will tear slits in your stencils at the ends of the blade. Center-mounted (floating) s
Electronics Forum | Tue Apr 21 02:28:54 EDT 2015 | dinhhuunam
Juki GL-1.... Any thoughts? I'm New to the > industry and I'm trying to buy a new screen > printer. I have two in mind, DEK and Juki. Hi Sir, I'll advise you the SJ INNOTECH Vision Screen printer Best Solution & Service for You Model HP-520S Hi
Electronics Forum | Tue Sep 07 15:28:13 EDT 1999 | Earl Moon
Listed below are the issues Viking has been experiencing since the installation of the Proflow Head: 1. After installing new 350mm Wiper foil with metal strip glued on it, It worked for about a week and suddenly metal stri
Electronics Forum | Wed Sep 08 08:25:26 EDT 1999 | Brad Kendall
Listed below are the issues Viking has been experiencing since the | installation of the Proflow Head: | 1. After installing new 350mm Wiper foil with metal | strip glued on it, It worked for about a week and suddenly meta
Electronics Forum | Wed Aug 18 15:20:25 EDT 1999 | John Thorup
| Hi, | I'd like to ask some tips about the merits and shortcomings o | of both screen printer and stencil printer. For small quantity and highly mixed usage, which type of printer is suitable to our | application? | The boards contain no BGA and
