Electronics Forum | Mon Mar 07 09:44:49 EST 2005 | anonomous
The machine sees a magazine, but with wrong number. somehow one (maybe more) wire from the magazine bus does not reach slot 3, as the other slots work, there is probably not a short, as the magazine bus work for other slots, the problem is probably i
Electronics Forum | Thu Mar 10 15:13:31 EST 2005 | pmd
I agree with SirTec. Conflicts with other magazines slotted into machine often cause un reckognized magazine errors elseware. You can also try to re seat the first pair of MOT driver cards in computer this is whare mag data is stored. Also a loose ca
Electronics Forum | Fri Apr 01 01:26:17 EST 2005 | Marv
A couple of things.. 1) The problem is more than likely on the magazine board itself (TC2), most likely the pal chip that stores the serial number and feeder information (you could swap this with a working magazine to verify) 2) The magazine connecto
Electronics Forum | Tue May 07 16:19:47 EDT 2013 | dyoungquist
The "25v reads 3V" part of the error message may be your clue. Since the machine runs for a while and then shuts down, something may be failing after it warms up. "F-AXIS-182:C-AXIS NOT properly out when expected" refers to the centering jaws not o
Electronics Forum | Mon Nov 28 13:03:15 EST 2011 | navin
Hi I am have some issuse with mydata machine my9 zmout.They machine is take a very long time to exchange tool form the bank and placed parts , i was told I need to replace the head,the bearing is bad,I replace the zmotor about 5 months back and the
Electronics Forum | Sun Jun 12 01:38:47 EDT 2022 | mikevb
I'm having a problem with my Mydata My9 pick and place. Basically whenever I try to run the placement calibration program or try to have the machine find fiducials, or basically anything with precision, the machine displays a X MOT motor timeout erro
Electronics Forum | Mon Jul 18 18:02:31 EDT 2005 | seaK
Thanks for the response..... The solder is actually printed okay prior to SMT.... And after placing, found missing solders at middle terminals of 0408 resistor arrays.... Package library is checked, component spec looks fine... I am suspecting the
Electronics Forum | Fri Feb 03 10:34:09 EST 2017 | prdmm1
PANASONIC ERJ-12ZYJ203U i am having a lot of problems picking this resistor up. i have purchased a new tool per engineering (NOT the problem). it seems the my9 is picking up then dropping it. then the machine goes to pick another and picks the dropp
Electronics Forum | Wed May 26 12:20:38 EDT 2010 | emrtech
we are currently running 0201 components using the c-14 tool on the my9 pick and place and are having a lot of missing components with in the PCB's. is anyone or has anyone had this problem? if so, were you able to finf a fix for it?
Electronics Forum | Fri Sep 05 09:33:32 EDT 2014 | cflames17
It could very well be the Safety Relay located inside the ELMO PSU (Bottom left in computer cabinet). I just had the same problems on 2 MY9's within 2 months apart. the Part cost around $700.00 from Mydata (Now Mycronic). These fail commonly with old
