Electronics Forum | Fri Dec 27 07:20:38 EST 2019 | dipak123
We have Mirtec MV-6 OMNI machine. If programer changes in part number ,then that part x-out from it's place.Value of X & Y incresed 10X compare to other parts in ATT.
Electronics Forum | Thu Apr 27 08:42:22 EDT 2017 | pvasquez
Hello M. We are a low volume high mix manufacturer with a total of 7 Mirtec AOI machines including a new MV-6 OMNI 3D system. I am very pleased with this machine! When we did our 3D AOI research, my team narrowed the field down to 2 vendors, Mirt
Electronics Forum | Tue Apr 27 10:40:36 EDT 2021 | mikekeens
Hi, I'm currently in the process of evaluating a number of 3D AOI machines such as Koh Young Zenith Alpha HS+, CyberOptics SQ3000, Mirtec MV-6 Omni, Parmi Xceed L and Aleader ALD8720S. Does anyone have any thoughts on these machines as to which is b
Electronics Forum | Sat Aug 03 07:46:25 EDT 2019 | makersan
Hi to everyone, We want to buy an AOI machine, What are the essential features for the AOI machine? We couldn't decide between 2D and 3D, our highest component is about 2cm. The smallest case we use is 0402. Which product should we choose consideri
Electronics Forum | Thu Oct 11 16:23:28 EDT 2018 | bdamico
Hello Doug, Thank you for the reference on our vintage MV-3L systems. It is always a pleasure to receive positive feedback from our valued customers. I also saw that you were in the market for 3D AOI. Are you familair with our MV-3 OMNI Desktop 3
Electronics Forum | Fri Apr 28 10:12:55 EDT 2017 | clampron
Hello M, I have been a Mirtec user for quite few years (not dating myself). I had started with the MV-2 system and sequentially upgraded to the MV-3 and now the MV-6 Omni. We had tremendous luck with the MV-3 from a programming and defect detection
Electronics Forum | Mon Sep 28 14:27:08 EDT 2009 | soudomphong
I need help with conveyor speed in Omni Excel 7. It fluctuate, and never have a steady speed. I swapped the speed control card,calibrated, encoder, and I still have the same problem. Any help would be appreciated, thanks.
Electronics Forum | Fri Nov 06 07:46:33 EST 2015 | clampron
Good Morning RedChilli, I have worked with Mirtec for quite a few years. I have looked at some of the other machines mentioned but have no practical experience with them. I started with the Mirtec MV-2 (long ago)due to the success of this platform,
Electronics Forum | Wed Sep 27 15:57:33 EDT 2006 | SWAG
I wanted to post resolution on a reflow oven problem we had but can't seem to search out the old thread. So, this is new but old. Our OmniFlo 7 conveyor was stopping every once and a while and the speed indicator on screen said 1000+ ipm. We cle
Electronics Forum | Mon Aug 14 02:24:20 EDT 2006 | AR
When we had problems on our Omni 5 with fluctuating chain speed, the problem turned out to be the Dart speed control board. After replacing the board the problem went away.
