Electronics Forum | Wed Sep 12 11:01:49 EDT 2007 | leemeyer
We have an Omni 7. We were having problems where blowers wouldn't start. Turned out to be the start capacitors and not the blowers. I replaced all of the caps and haven't had any issues since.
Electronics Forum | Tue Sep 29 13:03:01 EDT 2009 | soudomphong
Thank you for responding. I called Speedline tech support he think there is a short some where in the motor. I changed the motor out and still have the same problem. The chain is normal, and using automatic lubricating. I will check more into this, a
Electronics Forum | Wed Oct 07 10:04:07 EDT 2009 | soudomphong
Thank you for responding. I called Speedline tech > support he think there is a short some where in > the motor. I changed the motor out and still have > the same problem. The chain is normal, and using > automatic lubricating. I will check more
Electronics Forum | Tue Mar 21 07:31:54 EST 2006 | cyber_wolf
We had the exact same problem on our OMNI 10. We found that two of the rails the pin chain rides in were warped. Somehow at one point our PC lost communication with the oven and the heaters went wide open for several minutes...this is what caused th
Electronics Forum | Tue Sep 11 08:36:53 EDT 2007 | cyber_wolf
We seem to have a lot of blowers going bad on our Omni 10 lately. We run PB free and/or elevated sn/pb profiles on a regular basis. I am starting to suspect that the elevated zone temps are causing the blowers to fail. Has anyone else had this prob
Electronics Forum | Tue Sep 29 12:07:40 EDT 2009 | swag
The electronics degrade over time and you get troubles like you're having and you need to install a "noise reduction kit". Basically it's a new interface card set and some cables. You might call Speedline and ask tech. support if this is something
Electronics Forum | Wed Jan 24 22:38:45 EST 2007 | electrovert
Hello, My first time post up here. I have a problem with thermo runaway on upper zone #5 on the Omni 10 Electrovert. We changed the thermocouple #5 but the problem came back up. We swapped Sensoray board 8 and 9, swapped board #3 (T/C interface boar
Electronics Forum | Thu Feb 10 16:45:36 EST 2005 | pjc
It all depends on what type of board you need to solder. If your boards are small in size and low thermal mass and your conveyor speed requirments are normal, then I'd say the OmniFlo 7 will do the job. It has a max zone temp setting of 280C. The cur
Electronics Forum | Tue Jul 27 11:32:20 EDT 2004 | dwanzek
Thanks for the input guys. One problem with this theory, we see the same failure using Omni 5000 solder paste. We also see this problem across 4 production lines, suggesting it is not oven related. The profile meets recomendations and we have tried
Electronics Forum | Fri Apr 19 09:41:45 EDT 2002 | angiewest
We have been building BGA's for a couple of years. We even use a Universal Omni 4766 to place them with. Reflowing is where I thought we may have problems, Since we have an IR oven. But we bought a .010" thermocouple from Omega to measure the BGA
.png)
