945 procedure making program results

Electronics Forum: procedure making program (Page 1 of 95)

procedure to define programmable IC marking

Electronics Forum | Fri Nov 16 18:07:54 EST 2007 | wayne123

The way that the last two companies that I have worked for do is, as soon as the I.C is programmed it is marked with a either a gray or Yellow sharpie (just a small dot) in addition we always tried to make sure that this dot was at the end of I.C whe

Flux residue cleaning procedure

Electronics Forum | Mon Oct 30 20:24:35 EST 2006 | davef

As we understand it, you: * Get some nice BGA from your supplier * Find BGA to be packaged properly * Bake the BGA for 24 hours at [what temperature?] to reduce the potntial for damaging moisture sensitive components during following processes * Remo

IP3 special program

Electronics Forum | Fri Jul 29 18:49:03 EDT 2011 | marcelll

Hi guys, I'm looking for a special calibration program I need to complete a IP3 part camera calibration. This is to use the button jig in the procedure. They name the program IP3_camera_proper in the procedure. Anybody having a copy ?

Feeder maintenance program

Electronics Forum | Fri Nov 13 11:41:37 EST 2009 | gregcr

Hi All, I am implementing a proper feeder maintenance program for my HSP chipshooter feeders. I have the calibration jig. I am developing a procedure with the following general steps: 1. Cleaning 2. Visual Inspection / Repair 3. Calibration / Testi

Equipments required for making SMD PCB's

Electronics Forum | Sat Jun 27 00:23:26 EDT 2009 | grantp

Hi, This is easy. If your just doing prototypes, then you could get by with a syringe of solder paste and a hear gun. You can put down a little solder paste on each page and then place the passives and heat gun the board. If you have other active p

IP3 special program

Electronics Forum | Thu Aug 04 22:02:25 EDT 2011 | fujiphil

IP3 camera calibration, you need the following: 1. Part camera resolution Jig. 2. 10mm nozzle for nozzle centering. 3. Button jig (skip). 4. Glass board and Glass parts. 1. Conduct the Camera resolution. Set the following Delta values: X=+/-0.1mm;