Electronics Forum | Thu Oct 26 08:48:06 EDT 2000 | ptvianc
Of all of the process steps, paste printing is the most critical with respect to minimizing defects. Therefore, paste printing must be tightly controlled, particularly in the case of fine pitch (peripherally leaded) devices and BGAs. I believe that
Electronics Forum | Wed Oct 17 17:51:44 EDT 2001 | davef
This is a GREAT question!!!! Our process is similar, but our times are greater. Guess it's all dependant on the pressure on the pipe, eh? The faster money goes flying out the window, the less time there is for nicities.
Electronics Forum | Fri Jan 28 18:44:00 EST 2011 | rodrigo
Yeap, It did! Thanks.
Electronics Forum | Fri Aug 17 10:18:47 EDT 2018 | charliedci
This might help. See attached:
Electronics Forum | Tue May 07 22:41:32 EDT 2019 | pcbindex1
PCBs applied in vehicles are the fastest growing sub-industry
Electronics Forum | Thu Aug 16 09:15:15 EDT 2018 | muzzy
Sarason, thank you very much for your reply. I already have this manual but, unfortunately, it only mentions this elusive "MS Parameters" window but doesn't state how to get there and what is the password. Regards, M.
Electronics Forum | Thu Aug 16 09:10:45 EDT 2018 | sarason
I have a Juki KE750 Instruction Manual if that is of any use sarason
Electronics Forum | Fri Aug 17 07:27:47 EDT 2018 | stephendo
A lot of machines have such parameters stored in an ascii file that can be edited with notepad. But of course doing so could be the fastest way to destroy a machine with a typo.
Electronics Forum | Fri Aug 17 10:44:19 EDT 2018 | muzzy
Hello charliem. Thank you so much! Yes, it looks like the information I need. I will try it and report back in a few days. Thank you once again! Regards, M.
Electronics Forum | Thu Oct 26 08:33:25 EDT 2000 | M. Pirttimaa
I would like to read your opinion of the following matter: How wide is the window for good pasteprint quality if the quantity of paste is its indicator? Usually the amount of paste on landings varies quite a lot from set to set and there are signif
