Electronics Forum | Tue May 29 17:24:28 EDT 2001 | hussman
OK, I have a new product being tossed over "the wall" that has a flex circuit layered into a standard FR board and protrudes out of it. The flex circuit is 0.022" thick and is the 3rd layer of 6 layers. The total board thickness of the FR board is
Electronics Forum | Fri Jun 08 09:39:29 EDT 2001 | mriddle
Dear Mr. Chan, ASC International apologizes for any confusion or mis-representation you have experienced. It is unfortunate that we did not receive your email regarding local S'pore ASC distributors. If, after all this, you may still have an int
Electronics Forum | Wed Jun 20 21:20:00 EDT 2001 | davef
Try: * KINNARNEY RUBBER 450 Main St. P.O.Box 37 Mantua, N.J. 08051 609-468-1320 fax 7438 http://kinnarney.com/ * Dempsey Industries 802 N. 4th St Miamisburg, Ohio 45342 (937)-866-2345 Gary Pascoe * Shercon 10425 Slusher Drive � Santa Fe Springs, CA
Electronics Forum | Wed Jun 13 18:04:00 EDT 2001 | traviss
It is possible with a few universal profiles. I did this with 3 temperature ranges and 3 speeds for each, 9 profiles total. With this setup I could run any of about 150 boards most of them in the middle 3 profiles. My goal was to reduce change over i
Electronics Forum | Mon Jun 18 21:20:17 EDT 2001 | davef
It�s sometimes tough to put enough paste on the board before reflow to obtain half-way adequate hole fill with components on a 0.062 inch thick board. So, a 0.093 incher, um. Yano, a lot is determined by board lay-out and how you jigger your profil
Electronics Forum | Tue Jun 19 17:33:09 EDT 2001 | genny
We don't actually leave the residue on the board, even though the Kester spec sheet says it is ok not to clean - we do spot hand cleaning with Safety Wash. Kester also said that there shouldn't be any problem with mixing RA with no-clean, although w
Electronics Forum | Tue Jul 03 15:45:04 EDT 2001 | genny
No, I haven't even gotten around to formulating my test plan (what PCB to use, what lab to use, etc, etc,...ad nauseum), let alone convince my company that we need to do it. I also got caught up in another extremely tight deadline project and haven
Electronics Forum | Fri Jun 22 05:03:29 EDT 2001 | wbu
no - can it be left uncleaned on the board? ---> for many applications yes says our supplier and many companies do ( techi over there) - are our products specified for conditions that we and our customers can live with that? ---> well, at first
Electronics Forum | Mon Jun 25 11:09:26 EDT 2001 | wbu
Who is this, another Dave F ? For me there�s no problem with balling and beading. I know that the boards I have with the new paste do have all what�s needed for balling and beading, just one of the oldest designs with a stencil ...., oh boy, didn�t
Electronics Forum | Sat Jun 30 04:43:09 EDT 2001 | brendan
Hello We introduced OSP finish on some of our products but now need to add some discretes at the end of the process. From my little knowledge of OSP, this is difficult. We'll SMT the boards and transfer them to another site for further processing.