Electronics Forum | Fri Jun 22 06:16:02 EDT 2001 | pmathieu
hello, everybody we are looking for automatic system brand which are able to tape & reel components at end of mass production line thank you
Electronics Forum | Thu Feb 21 11:38:27 EST 2019 | jimpat
You should list the machine brands and models of each system.
Electronics Forum | Tue Mar 22 06:03:55 EST 2005 | Base
Try the IPC-254x CAMX standards (webstds.ipc.org, no www prefix!). They define a set of generic and process-specific XML messages for equipment to send out all sorts of process-related events. I know there are standardized messages for print, dispens
Electronics Forum | Thu Nov 30 11:10:36 EST 2000 | DL
Can anyone point me in the direction of where to find some lead placement equipment. Currently we have Clip leads that come in reels with solder pre attached are currently done by hand. surface mountable leads/connectors will not do, due to board/end
Electronics Forum | Mon Mar 13 19:16:33 EST 2006 | dynamic
Hi Steveo, What sort of products are you using the vacunest on? ie: PCB thickness, panel size, complexity etc... What brands and types of screen printers are you using? - Did you have to modify your printers? Do you also use it in your placement
Electronics Forum | Mon Mar 11 12:58:31 EDT 2024 | denism
Hi Dima, A past job used a PSE 300 from KOLB for 10 years. With proper maintenance, no problems were found. DST InJet was used in another production. As far as I know, there were no problems either. DST also has an interesting option, such as measuri
Electronics Forum | Tue Feb 28 09:22:12 EST 2006 | Mity-C
We have just had gridlock installed on 4 DEK screen printers. I agree that if it partially catches a component you will have misprints. In the same respect, if a hard pin is placed in the wrong location, you will get misprints and or damaged componen
Electronics Forum | Tue Feb 28 16:45:23 EST 2006 | charlie
Why don't you try it for yourself. It won't cost you anything in most cases. Anyone with a negative impression about the product may want to contact Grid-lok (support@grid-lok.com or sales@grid-lok.com) for applications or tech support to be sure th
Electronics Forum | Tue Mar 05 14:06:41 EST 2024 | mistrthou
We don't own one, I'm a bit interested to see what you end up with. We do have a triden pcb wash, and I know Aqueous Technologes makes a lineup of misprint and stencil cleaners. We had an engineer in from Zestron chemical company, and while they don
Electronics Forum | Thu Feb 16 09:37:11 EST 2006 | mgillespie
hi, > > we tried to introduce form-flex a few > years back and it caused more problems than it > fixed. > > Switched back to pins and no > problems. > > It might have improved since but I > would be reluctant to get them again unless I was >
