Electronics Forum | Tue Nov 17 08:36:28 EST 1998 | Chrys
| For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave solder a
Electronics Forum | Mon Nov 23 19:34:51 EST 1998 | Mike Demos
Charles: Here are a few possibilities you might want to check: 1) Conveyor width -- if the conveyor is too tight this will cause the boards to buckle as they go through the preheat section. We recently had this happen when we changed operators. 2
Electronics Forum | Thu Jan 09 19:55:14 EST 2014 | padawanlinuxero
Hello! I have a problem with one of the products here, we use a pallet to run the board on the solder wave, when the board gets solder and you inspect the board you notice that for some reason the first pcbs that touches the wave are ok, even a litt
Electronics Forum | Fri Jan 10 11:36:03 EST 2014 | rgduval
One thing you could check/monitor is the temperature in the pot/wave. As boards run across the wave, they will cause fluctuations in the wave temperature. The heaters should hep with minimizing this; but, if you're running a lot of boards in quick
Electronics Forum | Wed Nov 18 21:58:17 EST 1998 | Dave F
| | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave sold
Electronics Forum | Tue Nov 17 09:24:24 EST 1998 | Earl Moon
| | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave solder
Electronics Forum | Thu Nov 19 09:01:00 EST 1998 | Dave F
| | | | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave
Electronics Forum | Thu Nov 19 08:20:04 EST 1998 | Earl Moon
| | | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave so
Electronics Forum | Thu Nov 19 09:55:47 EST 1998 | Dave F
| | | | | | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the w
Electronics Forum | Thu Nov 19 09:32:52 EST 1998 | Earl Moon
| | | | | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wav
.gif)
winsouce.jpg)