Electronics Forum | Sun Aug 05 22:17:16 EDT 2001 | mugen
Hi mates, fellows of the SMT community, Anyone used before, a (SMT) P&P m/c, operating on Linux platform, as its O.S ??? We are reviewing a P&P m/c of european origins, and I must say, all of us are rather impressed with the creative, application o
Electronics Forum | Tue Oct 16 06:08:12 EDT 2001 | wbu
Hi Dave, tweaking, oh yes, we did like it to have that job done and not have people sitting around waiting for work or beeing able to deliver on schedule. Nonconformity report, ...ummmmh, weren�t that big that we thought we needed it, actually the t
Electronics Forum | Tue Jan 15 17:06:04 EST 2002 | pjc
The Mydata machine's Y-axis moving does not affect parts already placed on the board. The machine has very sophisticated acceleration and deceleration to account for this. There are many users of Mydata machines running 0.3mm pitch and large heavy pa
Electronics Forum | Wed Mar 06 21:16:17 EST 2002 | davef
�What does 5 micrograms of chloride mean to me?� * With SIR testing, you can show no detrimental leakage currents under humid conditions, no corrosion, no metal migration, which are the big factors in figuring out electrochemical reliability. People
Electronics Forum | Thu Mar 07 09:03:03 EST 2002 | cabjerk
After the IP3 is stopped by any means ie. Estop, cycle stop, or machine runs out of parts, upon restart the table will go to load position, unclamp, reclamp, read the fids and then proceed as normal. The problem is that if we already have fine pitch
Electronics Forum | Fri Jun 14 13:19:15 EDT 2002 | mjabure
The first question is, is this a high mix, low volume environment or vice versa? If it's the former then Kens solution is something you might want to look into. Depending on your feeder set up you might check to see if your operators have been traine
Electronics Forum | Wed Jun 11 11:12:10 EDT 2003 | JB
We rarely use the tack-time on our machines, even if we run products that are populated with large components. ( ICS, Tant caps etc.) There is a default tacktime for each component on the component library, is called Speed Data. For the components
Electronics Forum | Tue Dec 16 06:42:51 EST 2003 | Kev
I am having problems achieving correct pre-heater temperatures with our Hollis solder wave. Our original "Verification Golden board" program uses a conveyor speed of 5ft per minute and pre-heat temps of 300, 350, 400 respectively. Our "golden Board"
Electronics Forum | Thu Jul 01 13:47:25 EDT 2004 | Tom B
Good Day! I am looking to purchase a Cyberoptics KS-Flex 18 AOI system, I have a couple of question that if you could answer, I would most appreciative. 1) Model and length of time used. Do they use AOI for all pwbs or just the more complex a
Electronics Forum | Tue Mar 01 19:52:11 EST 2005 | smtuser1234
Brad, If I were you I would not take advice from anyone on any forum. What you need to do is have all your requirements on a spreadsheet (i.e. part sizes, # of feeders, etc) and then call 2 to 3 minor players in the Pick and place arena and then call
.png)