Electronics Forum | Mon Dec 16 04:26:28 EST 2019 | fidra
Hello, we have problem to install software on new hard drive, old one lost some files and can not be repaired by NT4.0 repair procedure. We have floppy with program and setup files for this machine. Thanks in advance
Electronics Forum | Fri Apr 22 07:22:03 EDT 2005 | Gene
Unfortunately the answer is no. These machines could not be run without line computer because the station computer does not have a program control software, it has the hardware station control only. Computers for SP-120 and HS -180 are the same but
Electronics Forum | Sun Dec 11 09:14:45 EST 2005 | andrew1007
Dear sir, I am a SMT engineer from China. I have diffculty in programming and maintenance of Siemens HS180,SP120.Can u send me some manual for the type of SMT machine.Thank you very much. my e-mail box is andrew1007@hotmail.com Regards!
Electronics Forum | Fri Oct 13 05:17:44 EDT 2006 | martin_m
Hi All, Does anyone know if it is possible to convert programs for the above machines into excel format. We have recently bought new machines and need to convert the programs. Thanks in advance Martin
Electronics Forum | Mon Jan 14 07:29:48 EST 2008 | benzy1961
We have an Agilent SP50 system. It is a 3-D system. The programming is pretty simple relative to some of the other machines we evaluated.
Electronics Forum | Wed Nov 17 10:47:47 EST 1999 | Rob Fischer
CDM is a quality material. Life expectancy can't be stated in time but should be termed in cycles. I'm aware of companies with more than 50,000 passes. These companies have a documented maintenence program for their pallets including PM and cleani
Electronics Forum | Wed Apr 27 11:13:41 EDT 2011 | jhinckley
I have a 1800w that the main contactor will not pull in. When i push the contactor in manualy the power goes through but nothing turns on, when i push in the fan contactors all fans come on. The programs seem to load butnothing happens and the sp and
Electronics Forum | Fri Feb 27 15:28:25 EST 2004 | DaveM
Both Cyberoptics inline (Cyber Sentry) and stand alone (LSM, LSM2 & LSM300) work well. As previously mentioned, the Sentry series inline systems work well, but reqiuire programming. The LSM series stand alone systems are good, but can be operator dep
Electronics Forum | Thu Oct 02 01:47:57 EDT 2008 | myleb
I'm new to SMT. Now, i'm making program for SPI machine to inscpect for solder paste of SP60-MU. I think this is a very good printer but some times, my program shows only 50-60% of volume transfer; and the average height is very high: nearly 200 pct.
Electronics Forum | Sun Jul 28 23:11:52 EDT 2002 | caldon
Sam - If I owned Cal Driscoll Electronics and were looking for a rework system a few things I would consider: 1) Convection is key (IR as an under heater or pre heat is ok but not as the main heat source). 2)programming simple? User Friendly and easy