Electronics Forum | Tue May 01 20:18:37 EDT 2001 | jwdyer
I have a PTF that is blowing the MMIT card on the PTF. Anyone have any ideas why? It's OK until the PTF begins the zero process. Thanks, Dyer
Electronics Forum | Mon Dec 05 09:14:14 EST 2022 | peterm
Invoke. The PTF Setup Procedure dialog box displays. 4. Select Product. The Select Product File dialog box displays. 5. Select the same product used in the Open PTF Teach Product section above. 6. Enter the Slot number for the PTF and select Full
Electronics Forum | Tue Jan 03 15:31:51 EST 2023 | griinder
I use a DTF instead of PTF, but one thing I wondered reading this...Which pocket do you designate as "First Pocket" for your tray in your Feeder.db? Could this be affecting the XY position being returned by the machine? For DTF I use upper left. Shou
Electronics Forum | Fri Nov 25 11:55:22 EST 2022 | poly
So I'm attempting to run feeder teach for my platform tray feeder... but I've got no idea what first point I should teach is... normal is the end pin of the feeder but this is for the ptf conveyor... so I've got no idea. If I just teach each corner
Electronics Forum | Tue Jun 19 09:02:34 EDT 2001 | Steven Sicard
Hi Does some1 have or know a website that would give me a list of tray definition (Size, Rows/Cols, Nest) so that I could use to help me with a PTF? Thanks!
Electronics Forum | Mon May 23 08:21:36 EDT 2005 | Dave G
Things that lower the maximum Board width: Nozzle changers,dual lane vs single lane, staged vs classic board handling, PTF, Comp Shuttle. Moving the changers into the feeder banks will increase your max avail width provided a shuttle or ptf are no
Electronics Forum | Mon Dec 12 09:02:30 EST 2022 | peterm
You teach the corners of the component picked from the previous steps. Just select "PTF RR BTWN RAIL" slot 75 in "feeder teach" and it should move over to the belt.
Electronics Forum | Wed Jun 17 10:02:38 EDT 2015 | rgduval
Having some issues with our GSM picking parts that are delivered by the PTF off center; and wondering if there's a relatively painless way to calibrate where the head goes to pick the part on the belt. Near as I can see, the PTF is picking the parts
Electronics Forum | Thu Dec 01 14:48:48 EST 2022 | peterm
Hi, The detailed instructions should be in Voyager under PTF Installation. It's basically a kit where you pick up a metal plate and you teach that component on the belt directly. If you don't have access to the kit I'd just start of with the default
Electronics Forum | Mon Dec 12 09:56:07 EST 2022 | peterm
Feeder Teach. Then it's the "Slot X,Y feeder teach" in the pulldown menu. That should be the default one, set feeder slot and the PTF as your feeder. If in doubt you can always make a back up in the feeder database as well. Probably a good idea eithe
