Electronics Forum | Fri Dec 19 17:11:24 EST 2014 | guts1872
My QSP2 motors keep shutting off with an error message on the screen that says Z1 motion fail. Z safe motion motion failed due to previous error. When homing the heads I observe the servo amp indicator LEDs. They are all green while the gantries are
Electronics Forum | Fri Sep 18 03:02:07 EDT 2015 | linux
Hello everyone. Need urgent help with our cp6, when front door is open servo amp alarm comes up, this error will clear using the reset button. Has anyone any idea how I would go about fixing this issue.
Electronics Forum | Tue Feb 01 14:26:53 EST 2005 | johnw
Just for starters you are experiencing a possible closedloop feedback error 1 your motor is on its way out 2 increase the reach pulse in propers 3 check gain of servo mail me for more info
Electronics Forum | Fri Apr 23 02:15:36 EDT 2010 | smellew
Hi Rodrigo, Have you fixed your CP65? do you need some help? llew
Electronics Forum | Fri Apr 16 17:44:40 EDT 2010 | rodrigo
We're still trying to fix a C-axis overflow error in our CP-65. I was swapping servo boards and one of them started to blinks a 2 on the LED single digit display and the machine didn't boot up. I replaced the servo board with a spare we bought on eba
Electronics Forum | Fri Jan 15 14:32:12 EST 2021 | marcelorotofrance
Hey there We have a second hand (or third or fourth...) Contact 3Z-100 non functioning, received as is. I am in the process to asses its condition and try to get a diagnosis. After DOS boot, 3Z.EXE executes and in the screen it reads: "Initi
Electronics Forum | Sat Jan 29 12:01:32 EST 2011 | jts142
hi i am having problems with a cp 643 when i run in auto it errors unloading a board with the x axis servo interlock error but if i hit sequence end stop so that it stops after every board it runs and unloads perfectly. Any hints or suggestions we ha
Electronics Forum | Tue Feb 01 13:21:34 EST 2011 | cyber_wolf
Try switching to a different board and see if the error goes away. If it does, it has something to do with one of the loader sensors not being made.
Electronics Forum | Wed Jun 25 18:19:49 EDT 2014 | guts1872
During machine run, sometimes when we stop to change parts the servos wont start back up. There is a message on the screen that says "Amplifier is resetting power". When that message clears and push the servo on button nothing happens. There is an er
Electronics Forum | Tue Jul 08 15:34:21 EDT 2014 | guts1872
Unfortunately it seems we have a worse problem than a Z rod spring. The machine was running fine this morning but ran out of a part, and when I shut the door and pressed Servo On nothing happens again. I shut down and let sit for a while. Now I get a
winsouce.jpg)