Electronics Forum | Thu Mar 14 10:49:44 EDT 2013 | babe7362000
Have others seen a higher rate of machine downtime due to the cover tape on parts not pulling back properly. We have the same problem on the Jukis and Quads. About every 3 minutes the machine stops and the operator has to pull the tape back. And in
Electronics Forum | Thu Jun 15 03:31:26 EDT 2006 | Bert van den Berg
The cover tape on 0805, 1206 and IC reels occasionally does not pull back clear of the tape and our Fuji IP-1 stops. Although some feeders appear to be more vulnerable to this than others, is this a feeder problem or is this a material problem with
Electronics Forum | Mon Mar 18 10:33:27 EDT 2013 | babe7362000
It is not the feeders having the issue. The tape on the strip of parts does not want to pull up easily. I just wondered if anyone else out there is having the same issue. Thanks for any feedback.
Electronics Forum | Fri Feb 07 20:38:16 EST 2020 | orbitcoms
I am running a Sasmsung CP40-LV machine (which itself works fine). However, the thing holding up production is that I am often experiencing tape cover not being pulled back by the feeders. What part of the feeder is most likely to cause this? I have
Electronics Forum | Fri Jun 16 10:12:16 EDT 2006 | flipit
It it PSA tape or heat seal? Every machine I have ever used has trouble with PSA cover tape. I wish they would ban in in ROHS. 3M tells me it is the future and it will replace heat seal tape.
Electronics Forum | Wed Mar 20 18:11:10 EDT 2013 | garym4569
Is the problem with the same component or manufacturer? Just for kicks, load a different component on the same feeder. Run machine in trial mode and place only that component on double sided tape. Gary
Electronics Forum | Thu Mar 21 22:27:13 EDT 2013 | padawanlinuxero
Hi ! I have the same problem with some rolls of tape, we did check the feeder magazines in our mydata machines but turns out the problem is with the plastic cover sometime it comes with just too much adhesive that the feeder magazine cant peel the p
Electronics Forum | Thu Jun 15 08:44:18 EDT 2006 | jdengler
Bert, The original IP feeders do a poor job of peeling the cover tape. Things to check: -All teeth present on the take-up reel -Take-up reel has even drag as it rotates (reel out of round or dirty) -Take-up reel drag is not too high (locations and
Electronics Forum | Thu Mar 14 17:35:39 EDT 2013 | dontfeedphils
Have you looked at the cover tape wheel on these different feeders and made sure that they are turning correctly when the feeder is advanced? There's not too many things that could be wrong, either the wheel isn't turning properly and keeping the co
Electronics Forum | Fri Mar 15 08:20:06 EDT 2013 | torch
we quite often see this on our quads usually only on the 8mm feeders, sometimes the tape roller can become sticky as suggested. usually i just remove the roller and apply a grease to the screw so that it can move freely also make sure that the peel
