Electronics Forum: pulling (Page 1 of 105)

Tape not pulling back on components causes machine to stop

Electronics Forum | Thu Mar 14 10:49:44 EDT 2013 | babe7362000

Have others seen a higher rate of machine downtime due to the cover tape on parts not pulling back properly. We have the same problem on the Jukis and Quads. About every 3 minutes the machine stops and the operator has to pull the tape back. And in

Metal foil is pulling away from the screen.

Electronics Forum | Mon Feb 19 11:46:56 EST 2001 | bphilips

We use an ultrasonic stencil cleaner (not Smart Sonic) and have problems with stencils falling apart. The metal foil is pulling away from the screen. Is this a common problem with ultrasonic stencil cleaners?

Tape not pulling back on components causes machine to stop

Electronics Forum | Mon Mar 18 10:33:27 EDT 2013 | babe7362000

It is not the feeders having the issue. The tape on the strip of parts does not want to pull up easily. I just wondered if anyone else out there is having the same issue. Thanks for any feedback.

Cover tape not always pulling back on Fuji IP-1

Electronics Forum | Thu Jun 15 03:31:26 EDT 2006 | Bert van den Berg

The cover tape on 0805, 1206 and IC reels occasionally does not pull back clear of the tape and our Fuji IP-1 stops. Although some feeders appear to be more vulnerable to this than others, is this a feeder problem or is this a material problem with

Tape not pulling back on components causes machine to stop

Electronics Forum | Thu Mar 21 22:27:13 EDT 2013 | padawanlinuxero

Hi ! I have the same problem with some rolls of tape, we did check the feeder magazines in our mydata machines but turns out the problem is with the plastic cover sometime it comes with just too much adhesive that the feeder magazine cant peel the p

Issue with Feeder not pulling tape covers back

Electronics Forum | Fri Feb 07 20:38:16 EST 2020 | orbitcoms

I am running a Sasmsung CP40-LV machine (which itself works fine). However, the thing holding up production is that I am often experiencing tape cover not being pulled back by the feeders. What part of the feeder is most likely to cause this? I have

Tape not pulling back on components causes machine to stop

Electronics Forum | Wed Apr 03 10:25:04 EDT 2013 | gregp

We all seem to have forgotten about cover tape peel force testers. GPD makes them as do others I suppose. I would ask the tape and reel house if they have a tester. If they don't I would consider using someone else. Otherwise as another poster s

Cover tape not always pulling back on Fuji IP-1

Electronics Forum | Fri Jun 16 10:12:16 EDT 2006 | flipit

It it PSA tape or heat seal? Every machine I have ever used has trouble with PSA cover tape. I wish they would ban in in ROHS. 3M tells me it is the future and it will replace heat seal tape.

Tape not pulling back on components causes machine to stop

Electronics Forum | Wed Mar 20 18:11:10 EDT 2013 | garym4569

Is the problem with the same component or manufacturer? Just for kicks, load a different component on the same feeder. Run machine in trial mode and place only that component on double sided tape. Gary

Metal foil is pulling away from the screen.

Electronics Forum | Mon Feb 19 13:49:44 EST 2001 | markkrmp

Bill, It is my understanding that in using the Smart Sonic to clean Adhesives from stencils and mis-printed boards it is recommended to have the system up to a certain heated temperature. What is that recommended temperature? Does this temperature

  1 2 3 4 5 6 7 8 9 10 Next

pulling searches for Companies, Equipment, Machines, Suppliers & Information