Electronics Forum | Mon Dec 18 14:11:02 EST 2023 | erikfriesen
Has anyone ever replaced the venturi vaccum pump on the CP45 or other series machine? Or used a centralized vaccum system? It works fine, but air consumption seems excessive. This is what is in there, it probably uses 10cfm at least. https://www.p
Electronics Forum | Tue Oct 22 20:32:16 EDT 2024 | jamesatqkits
I also use a small vacuum pump, this allows me to run a small compressor to supply air to the machine, around 7.5cfm. Someone suggested it to me years ago, the venturi system in the machine uses a lot of air and is noisy. The pump is a yellow jacket
Electronics Forum | Thu Dec 06 02:45:09 EST 2007 | mun4o
hi, we use pump print stencil and have problem with cleaning.we clean the stencil handling, using zestron301, but in the holes stay adhesive.Take a test with ultrasonic cleaner but resalt is not good.
Electronics Forum | Fri Aug 10 10:37:49 EDT 2012 | cyber_wolf
Has anyone out there ever successfully rebuilt a CP642 transmission cooler oil pump ? Any tips or tricks would be appreciated. Thanks
Electronics Forum | Mon Jan 29 13:06:48 EST 2024 | erikfriesen
A follow up, using an external vacuum pump works fine, and reduces load on the air compresssor, probably using 1/3 of the air.
Electronics Forum | Tue Feb 05 18:26:34 EST 2008 | janz
Hello, We have FCM base 2 machine (Philips-Assembelon). I am trying to find out whether it is possible to install instead vacuum pump (make noise and power consumption) venturi system. Does anyone try to do this.? What was the result.? What vent
Electronics Forum | Thu Dec 06 08:57:32 EST 2007 | davef
With this small amount of background information on the situation, comments are: * If you let adhesive cure on your stencil, you should not be using Zestron 301. A hammer and chisel is more effective. * Assuming you are not letting the adhesive cure,
Electronics Forum | Mon Jan 31 07:46:07 EST 2005 | EHess
Looking for a source for rebuliding Electrovert Econopak II, solder pump motors. Thanks
Electronics Forum | Wed Jul 19 02:37:24 EDT 2017 | bukas
Hello everyone, i recently got Ersa ETS 330 wave machine '94. I got it running and heaters and flux pumps are ok, but I have problem with 2nd wave pump. It runs for 10-15 sec and then shuts down with error message on display. I checked bearings and
Electronics Forum | Mon Feb 28 11:24:13 EST 2005 | EHess
Still looking for a second source for the Electrovert Econopak II wave solder pump motors, or a place that rebuilds them. anyone? Anyone? Beuhler?
