Electronics Forum | Sun Mar 12 13:09:33 EST 2000 | Jeff Wilson
Jeff, The problem you are describing MAY be related to the push up pin setting on your component feeder units. Please verify that the push up pin height is set correctly for the feeder units, and the nozzle pick-up and placement heights are to the c
Electronics Forum | Sun Mar 12 13:09:33 EST 2000 | Jeff Wilson
Jeff, The problem you are describing MAY be related to the push up pin setting on your component feeder units. Please verify that the push up pin height is set correctly for the feeder units, and the nozzle pick-up and placement heights are to the c
Electronics Forum | Mon Mar 13 08:59:21 EST 2000 | Jeff
Jeff, We do not use push up pin. The nozzle pick-up and placement heights are checked many times. We are looking for wich component can break the nozzles. Thanks for your help, Jeff.
Electronics Forum | Mon Mar 13 08:59:21 EST 2000 | Jeff
Jeff, We do not use push up pin. The nozzle pick-up and placement heights are checked many times. We are looking for wich component can break the nozzles. Thanks for your help, Jeff.
Electronics Forum | Fri Oct 01 13:14:10 EDT 2004 | dorklover664
The MPM's are the Yugo's. You can fix anything on it with duck tape and a rubber band. I would go with the DEK. They are user friendly and reliable. Just make sure that if you are running double-sided boards to look into good push-up pins. They have
Electronics Forum | Thu May 18 17:34:06 EDT 2006 | Frank
The Juki tape feeders are mechanically actuated. There is a knock pin on the bottom of the feeder bank that will push up to advance the feeder.
Electronics Forum | Wed Nov 01 00:19:29 EST 2006 | Cingular Man
Are you setting up double side PCB that has the tall components on the bottom that being push up by the support pins... ??? Or because your vacuum is leak and not holding the board at the same spot every time you are loading the board.... Board warp
Electronics Forum | Tue Jul 12 17:53:02 EDT 2016 | muzzy
Hi! If You have manuals in PDF form, I would be very grateful if You could send them at: muzzybox(at)o2(dot)pl. Thanks. Regarding Your problem with 0603 resistors - I'm not an expert when it comes to using this machine, but I think there could be a
Electronics Forum | Wed Jul 14 17:33:04 EDT 2004 | Ross Clunie
The short answer is "No" the white and green feeders are not interchangble. The green feeder has a channel in it to allow the "embosed" or plastic tape to fit flat at the pickup position. If you use paper tape in this type of feeder the tape can be d
Electronics Forum | Sun Mar 29 13:49:59 EDT 2009 | tpappano
Hi Peter, I'm a new user of a CSM84VZ, so I have only a small grasp so far about what goes on in the machine 8-) There should be two locating pins. One fixed and the other adjustable for different board widths. Small cylinders are coupled to the