Electronics Forum | Thu Sep 10 15:01:28 EDT 2009 | mefloump
I currently spray DOW 2620 with my PVA650 without any problems. I do not thin it but I do have a distance between the coating machine and IR oven to provide a flash off period. I notice bubbles only when the flash off time is too short and the coatin
Electronics Forum | Thu Aug 27 08:34:50 EDT 2009 | floydf
I am having trouble with little air bubbles in my conformal coat. It ranges from a few pin sized bubble to looking like spit. We are using Dow 2620 silicone conformal coat applied with a PVA sprayer machine. The conformal coat comes in bladder bags t
Electronics Forum | Fri Oct 09 16:07:30 EDT 2009 | dlabelle
We use Dow 2620 silicone conformal coat applied with PVA1000 sprayer machine. If used on a daily bases, we have no problem. If we let the machine sit idle for over a week, we will get bubbles in the conformal coating. Sometimes, purging the line w
Electronics Forum | Mon Oct 09 15:15:57 EDT 2023 | ushir
Good Day Please could someone assist with a copy of the Fastpath software for PVA 650 Conformal Coating machine. I have a copy of Pathmaster 4.0 should anyone require it. Thans
Electronics Forum | Wed Apr 19 16:43:05 EDT 2006 | samir
Silicone-based coatings "repel" most foreign,non-compatible materials like peelable solder mask, and rubber or vinyl boots. The result is, uncured material around the vicinity of where the boot was. Trust me. Been there and done that. As a rookie
Electronics Forum | Sat Aug 07 02:28:20 EDT 2010 | raghu
We have PVA 350 benchtop dispensing equipement with humiseal 1A33 CC material. is there any moisture measurement process in conformal coating material?
Electronics Forum | Mon Aug 09 07:13:08 EDT 2010 | raghu
We have PVA 354Bench top conformal coating machine. We are going to procure the Humiseal 1B31 material. Is this material is suitable for this model of machine? Is there any special pecautions to be taken while programming? What are the main problemsd
Electronics Forum | Tue Aug 10 01:02:31 EDT 2010 | raghu
We have PVA 354Bench top conformal coating machine. We are going to procure the Humiseal 1B31 material. Is this material is suitable for this model of machine? Is there any special pecautions to be taken while programming? What are the main problems
Electronics Forum | Thu Aug 20 02:17:09 EDT 2015 | armandogomez
Is going to be a lot of work to do something like that, money and time, why not buy something on the market? camalot is a good brand or PVA is another brand.
Electronics Forum | Sun Dec 26 23:48:01 EST 2010 | raghu
Dear Sir, We are using 1B31 conformal caoting of 48 sec viscosity in Zahn #1 cup, by machine(PVA354) application with Tank air pressure 2.3 psi, automising air pressure 1 psi. 7 days after application we are observing peeling off problem.. And n
