Electronics Forum | Thu Nov 04 21:36:36 EST 1999 | chris
Hi John, Thanks to your reply, just one question is it possible that the solder paste ( flux material )applied to the pads cause the non-wet. regards Chris
Electronics Forum | Fri Feb 24 19:22:58 EST 2023 | SMTA-71549289
From my understanding titanium is typically used for non-wetting nozzles, correct? And then wetting nozzles are made of other metals with a coating that allows it to wet.
Electronics Forum | Mon May 09 16:44:33 EDT 2011 | dcell_1t
Hi, We have been struggling with an issue of non wetting on a QFP (Renesas - 256, Sn90Pb10) but the issue "desapears" sometimes for a while and then back again suddenly. This is the scenario: Component: QFP 256 / Renesas / Sn90Pb10 / 0.5 mm pitch S
Electronics Forum | Wed Sep 10 04:23:42 EDT 2008 | gregoryyork
Wheres the Gold layer on the non wetted part of the pad
Electronics Forum | Tue May 31 10:58:31 EDT 2005 | davef
There are a host of possibilities. Virtually any fabrication process prior to outer layer manufacturing prior to HAL could contribute to dewetting. That goes all the way to excessive brighteners in the copper plating line. Anything that prevents the
Electronics Forum | Wed Jan 31 17:57:07 EST 2007 | blnorman
We've had multiple issues with non-wetting components. You say only one part is not wetting? Profile won't be the culprit, if so you would have more part issues. We've used SnPb with lead-free parts for some time now, no issues. The issues we had
Electronics Forum | Thu Mar 31 06:09:19 EST 2005 | amstech
Yes, components do contribute to the non wets in fine pitch reflow. Oxidation is the main culprit. May ask where it is coming from. Can not say in particular. May be burn in test process or end of line baking, hot / cold testing and need to run DOE'
Electronics Forum | Wed Sep 05 07:07:25 EDT 2007 | mun4o
hi, I have a big problem with soldering uP QFP144 package.All components in PCB are small, only this chip is big and I can't make good temperature profile.Solder joints of other components are shining and with good wetting, but in QFP leads solder j
Electronics Forum | Wed Nov 21 19:45:36 EST 2001 | Yngwie
Hi Guys, I need help. I�ve a trouble with non-wetting problem on the lead of 208 pin, 20 mils pitch QFP. We are on intrusive reflow. I never faced this problem before on this product after running them for about 2 years now. This occurred on one pa
Electronics Forum | Tue Apr 15 03:16:14 EDT 2008 | janz
Hello, We are having a problem with soldering QFP100 (16mmx16mmx1mm). Board dimensions: 70mmx50mmx1.8. FR4 two layers � single SMT assembly. Finish: HASL-lead free Oven: 7 zones �hot air Paste: lead free We have noticed that two groups of legs
