Electronics Forum | Mon Sep 20 00:51:03 EDT 2010 | jeffr
This particular Yamaha Head I/O Board is a common failure. Yamaha supply an updated version which is less likely to fail. The cause of the problem that you see is due to the connectors on the flexing and damaging the inner layers of the board. The on
Electronics Forum | Thu Oct 27 13:31:12 EDT 2022 | proceng1
It's a small screw adjustment. Ours is toward the input side. You can grab one of your boards, manually lock it in, and adjust until the light changes.
Electronics Forum | Wed Jun 16 08:16:27 EDT 2021 | shmevan91
Hi, Could anyone shed some light why a mk5 13 zone heller ovens rail width won't auto adjust? has to be done by hand every time we change product. The board support rail will adjust just not the main rail, have tried swapping the two cards around bu
Electronics Forum | Mon Jul 30 10:22:57 EDT 2007 | swag
Sounds like your board stop sensor is not working properly so it's not seeing the y-stop/board edge when the board enters the center or the machine. You could try taking the camera cube cover off, jog the camera over a board then move the board back
Electronics Forum | Thu Apr 05 07:41:57 EDT 2012 | aj
try 180 180 195 248 260 belt speed 20 ( lightly populated boards) adjust speed to 18 for heavily populated.
Electronics Forum | Thu Jul 05 20:54:27 EDT 2012 | actioncontrols
Hello: We have used our Phillips Topaz on a number of volume jobs and been very pleased. A while ago it became apparent that the vision LED's were growing dimmer as evidenced by having to adjust light intensities upward for various components in so
Electronics Forum | Tue Jun 12 17:13:05 EDT 2012 | kmots15
We only clean ones that are rejected (typically 1 out of 250 or more). Very well could be an issue with the boards supplier if your having a inconsistency in plating/hasl process, under a scope do the fiducials look the same between boards? More like
Electronics Forum | Thu Jan 19 04:35:35 EST 2006 | pavel_murtishev
Good day, I worked with Maratnz some time ago. My own opinion is that this is limited machine with limited functions. Main disadvantages are: - Rather costly, something about 100 KEUR per table top machine; - 2D scanning system (direct light module
Electronics Forum | Fri Sep 30 03:36:39 EDT 2005 | pavel_murtishev
Good day, 2D inspection requires correct adjustment. In the other case it will cause continuous problems and false alarms. Adjust the lightning first and choose the correct process limits second. Look at histogram when you are adjusting the camera
Electronics Forum | Tue Oct 17 18:15:39 EDT 2006 | daxman
Hey all, I just though I give you all a quick update. I managed to get the printer working. The problems were a combination of everything that was discussed here. When I adjusted the GS4 pot for the histogram, I turned the wrong one at first. This t
