Electronics Forum | Sat Jul 07 11:45:26 EDT 2012 | btipcb
I purchased and am setting up a used QSA30. It has been a little frustrating but I finally have an almost program. The isse is that I can not generate a placement program because it says that the ANC is not registered. I can look at it on the sy
Electronics Forum | Mon Jul 09 12:04:56 EDT 2012 | btipcb
After fooling around with it, I was able to clear that error. I didn't know that I had to assign nozzels to each part, I though the feeder assignment would do that. I appreciate the reply.
Electronics Forum | Mon Jul 09 12:36:43 EDT 2012 | bobpan
Once you optimize and you go into step program....the nozzles should be assigned to each placement. If it is not doing this....the optimizer is still not working the way that it should.
Electronics Forum | Mon Jul 09 11:52:21 EDT 2012 | bobpan
Does it show the ANC in a position on the feeder base in the screen that has the nozzles/hole positions? When you go to optimize ...there is a screen that has something to do with registered ANC.....There could be something there that is incorrect. I
Electronics Forum | Wed Sep 26 14:18:50 EDT 2012 | tank
Wondering how good the software is for the Quad QSA 30 is. Is it a pain to program? We have panels with 100 boards... 1500 parts, I hope you don't have to manually teach the whole panelized board. Any other info you can provide is welcome. We
Electronics Forum | Wed Sep 26 15:04:09 EDT 2012 | kahrpr
The QSA30 is basically a Samsung CP40 with a few changes. For an older machine the programming is pretty good. it can do array boards and has an import feature for XY data. Tts been about 7 years since I ran one. Its a pretty solid machine.
Electronics Forum | Thu Sep 27 05:47:21 EDT 2012 | bobpan
Check the software version before you buy it. If it is not version 6.75 do not buy it. This is the last version released for this machine and fixes many bugs that made running a panelized board a nightmare. 0603 parts and above is where i would stay
Electronics Forum | Fri Dec 09 14:37:04 EST 2005 | derengmao
I am using ver 6.50 software. Do you know Quad Align compared to Cyber or Samsung's own, which is better? Do you know if the QSA30V support non-symatrical Micro-BGA such as DDR2 DRAM IC?
Electronics Forum | Sat Oct 22 02:11:22 EDT 2005 | fastek
Tom Nisbit at PPM can answer anything regarding these machines.
Electronics Forum | Mon Jul 09 18:54:34 EDT 2012 | kahrpr
Make sure the board size is big enough. the placement can not be outside of the board size.
.gif)
