Electronics Forum | Wed Nov 22 15:09:52 EST 2000 | Finepitch Services
Chryzs, I've used AIRVAC and SRT (with their old adjustable 4 piece nozzle system). I also saw the APE Chipmaster... Here's my 2C after all that: Whoever claims he/she has a user friendly system is a big liar. The words are correct but the order is
Electronics Forum | Wed Feb 06 06:32:06 EST 2013 | bandjwet
We have been running both SRT and APR rework systems for many years in our business as a service provider of BGA rework (http://www.solder.net/services/bga-rework-services The SRT is a true workhorse with good bottom side heating capabilities. If yo
Electronics Forum | Wed Dec 20 11:04:01 EST 2017 | junkeymonkey246
Perfect! Thank you bobpan! Shes up and running again.
Electronics Forum | Wed Dec 20 10:04:07 EST 2017 | junkeymonkey246
Hello there, I work at Redcom Laboratories in Victor NY. I'm a student and new to being a machine repair technician. I'm having some bother with one of our TYCO QUAD QSP-2 machines. I keep getting the errors: "WARNING: Head#2 Nozzle RUNOUT=27.1 mi
Electronics Forum | Fri Jul 09 23:45:22 EDT 2010 | dman97
I have a CP642 machine that always gives me a Station 17 or Station 19 nozzle error when the machine selects the 2.5mm 3.7mm or 5.0mm nozzles. It always throws an unknown nozzle station 17 error after all the heads have switched to the above mention
Electronics Forum | Wed Nov 04 10:28:04 EST 2009 | vetteboy86
Its been a while since I've worked with a QSP-2 > but I seem to remember that they should have a > puff off value where the machine will actually > blow the part off of the nozzle. I think it was > adjustable under the component handling but I >
Electronics Forum | Sat Jul 26 12:37:10 EDT 2014 | jimmyboz
In the future, please try to explain the situation with some detail. Usually this is the sensor on the 10th station to verify to nozzles are in the up position.
Electronics Forum | Thu Jul 03 11:27:06 EDT 2014 | bobpan
Try these things: 1. Reseat the cards (with power off) and Reboot the machine and see if the errors clear. 2. Unplug the nozzle changers and try to reboot....sometimes they can mess up the system. 3. If all the above fails.....the b-rams in the card
Electronics Forum | Wed Dec 20 10:44:31 EST 2017 | bobpan
The z-rod bellows on head 2 and head 3 are slightly bent. The machine will show you this error if the runout is over 6.5 mils. This is usually caused by too much z when picking parts out of a vib or tray feeder. The machine will probably run. I ha
Electronics Forum | Wed Nov 04 07:39:34 EST 2009 | vetteboy86
We have started using an RGB LED and today ran the first boards down our line. I noticed an immediate issue with placing these. I'm using a quad QSP-2. The part sticks to the nozzle. The nozzles are clean. I have adjusted machine handling so that vac
