Electronics Forum | Mon Jul 18 08:57:31 EDT 2005 | tommyttr
It is either the axis card, or the head bd. reporting corrupted data
Electronics Forum | Mon Sep 14 16:36:40 EDT 2015 | simons
Upon start up our QSA machine is giving us the following errors. Cant reset motor alarm (x axis) Cant reset motor alarm (y axis) Cant reset motor alarm (z axis) What are the possible reasons for this? Thanks
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
Electronics Forum | Tue Nov 13 11:41:23 EST 2012 | dontfeedphils
I can't remember what motor control cards in the machine are interchangeable, but if the controller card for the theta axis is a common control card then you can swap out the one currently controlling the theta axis with a different axis and see if t
Electronics Forum | Thu Aug 18 02:39:21 EDT 2016 | epsltd
We have a Mirae 1030 and when the machine warms up the y-axis fails and we are unable to reset servos unless we leave machine powered down few hours. Now since we have changed servos after machine homes we jog the y-axis and it vibrates and very nois
Electronics Forum | Mon Jul 18 07:11:37 EDT 2005 | geb
Does anyone know what an "Axis Head 1 Theta DAC limit error during Move Absolute Command" may mean? It occurred during production. I have checked through the board's program for errors but cannot see any.
Electronics Forum | Tue Feb 11 00:21:54 EST 2014 | bren
I suddenly encountered this error F-AXIS-C/9 Error says Axis has unstable zero point. Any advise?
Electronics Forum | Thu Apr 28 05:52:21 EDT 2022 | sophyluo1985
Please send the error message to my email quinnsmt@gmail.com
Electronics Forum | Wed Feb 13 15:13:48 EST 2019 | slthomas
What is the R axis? Is that the nozzle?
Electronics Forum | Tue Feb 12 12:45:13 EST 2019 | aldrich17
Yes we do. I've done the R-axis sensor calibration multiple times in the past few weeks due to FNC Nozzle sensor errors, as well as R-axis errors. Do you suggest i go through the entire process of the Head Assembly Calibration? From section 15-1 thru
winsouce.jpg)