Electronics Forum | Thu Mar 28 15:18:21 EDT 2024 | tey422
From the error message, might have to do with the "Z"-axis. You didn't mention you redo the calibration or not, then you should run that too. My guess would be "Z reading maybe slightly off". BTW, last time I work with those Mydata machine were bac
Electronics Forum | Wed Aug 22 15:48:03 EDT 2012 | rmitchell
Hi, Our CP8 is down with this message. Parameter: EMG FjMcEmgservoEnable CAM(0),FjlSrvAxis Reset R=304087143 The machine error also has possible broken wire. None of the servo amps show an error they are all (bb) on the led read out We do not hav
Electronics Forum | Thu Jan 11 19:18:24 EST 2024 | madisreivik
Hello ! FUJI IP3 left head sometimes places component with rotation error. Vision processing SHOWS that component needs rotation Mechanical side is checked, looks fine. Also, changed servo, no effect. It happens randomly, maybe 1 part from 30. It
Electronics Forum | Wed Nov 16 18:20:39 EST 2011 | dontfeedphils
According to the message guide it just says that it's a error telling you to initiate the Hydra Theta axis. I suppose the encoder for the hydra theta motor could be losing count and causing it to need to be re-initiated, or it could be something to
Electronics Forum | Thu Aug 04 09:40:12 EDT 2022 | jojoled
Hi, did anybody face such error(attached)? After calibrate all axis I get this error. "E202074 : Z axis of left head : SERVO alarm. Turn off the power to the machine and perform inspection" - see attachement. Machine was fully working day
Electronics Forum | Mon Nov 26 02:09:55 EST 2018 | bukas
yes I am, today im going to try to load backup image on to HDD. this error occurs before any machine movement, so it might be SW error... at least I hope so
Electronics Forum | Mon Apr 19 16:07:32 EDT 2021 | sacd
Hello. When I am originating machine Juki KE20060RL Error On Initializing appear Z4-axis. The position error exceeded the limit. I am check and diagnosed that motor Z don't move at all. Attached axis monitor shows the current state of the axis . Coul
Electronics Forum | Tue Nov 20 02:26:11 EST 2018 | bukas
hello everyone, I have this problem with one of my machines. it reports EMER error code: e804 "the scale of X axis can not be detected" has anyone encountered such error before? any idea what could cause it?
Electronics Forum | Thu Jun 10 22:13:01 EDT 2021 | roycet4
I would start by replacing the Z axis motor for head #4, you previously mentioned there was also a theta axis issue with head #4, you might be best served to replace both motors. These motors do go bad from time to time, We have 28 Juki machines wher
Electronics Forum | Thu Jan 18 10:05:44 EST 2007 | SWAG
Make sure the program has been optimized to the current nozzle configuration.
