Electronics Forum | Fri Nov 26 10:28:09 EST 2010 | cruoff
QA Error #0 The strange part is that if I reprogram the Pickup over and over again, using the same variables, eventually the error goes away and does not return for that particular pickup. However it will occur again for subsequent pickups. Has
Electronics Forum | Mon Nov 29 16:28:24 EST 2010 | jmw
If i remember this correctly....and its been years.......check to see what your theta number is for the pickup or placement. The number has to be 1 of 4 values.
Electronics Forum | Tue Nov 30 09:27:34 EST 2010 | kpm135
Its been a long time since I've worked with the Quads but if I remember right I've seen this error when the bearings went bad in the theta on the heads. Usually you can feel it when you try turning the Z-rod. Should be a nice smooth motion with littl
Electronics Forum | Mon Nov 07 13:52:10 EST 2011 | leemeyer
Can anyone supply me with the default MOD codes for a Quad 2C. I have recently picked up a used one and am having trouble getting to run properly. All I have is codes for a 4C. Thanks
Electronics Forum | Tue Nov 08 15:07:51 EST 2011 | gosswald
I have been in the process of setting up a Quad 2C that lost its mod codes myself. Have you cleaned the glass encoder strips for X and Y? I was getting alot of motor errors until I cleaned them and I believe it was the error 4. Hope this helps.
Electronics Forum | Mon Nov 21 14:25:44 EST 2011 | mosborne1
Bob, The one at CASI did the same thing. Did we ever get that one to work?
Electronics Forum | Wed Nov 18 14:09:28 EST 2009 | cyber_wolf
Please let us know how a 10-15K Quad 2C works out for you if that's what you decide on.
Electronics Forum | Thu Mar 24 09:33:45 EDT 2011 | bobpan
An old quad 2C/4C with a workholder will probably fit all those numbers. 2Ft is pretty long though and that might be a little too long. Machine price range is about right. Programming is pretty easy. Good luck
Electronics Forum | Mon Nov 07 14:15:02 EST 2011 | bobpan
There are different sets of mod codes depending on the firmware version on the machine. One of the function codes can tell you what firmware you have and if its quadalign or cyberoptics. Re-post and maybe i will have the version you need.
Electronics Forum | Tue Nov 22 05:44:05 EST 2011 | bobpan
I thought the the machine was slowed down to speed setting 1 for the x/y axis and the machine worked. I think the x-motor was on its way out.
.png)