Electronics Forum | Wed Apr 01 07:52:12 EST 1998 | Martin Plourde
I have a customer looking to buy Quad 3C Feeders. He is evaluting the possibility of either buying these feeders or buying a whole Quad Pick and Place. Qty: 30 8mm Feeders
Electronics Forum | Wed Apr 01 07:52:03 EST 1998 | Martin Plourde
I have a customer looking to buy Quad 3C Feeders. He is evaluting the possibility of either buying these feeders or buying a whole Quad Pick and Place. Qty: 30 8mm Feeders
Electronics Forum | Wed Apr 01 10:17:19 EST 1998 | Stefan Witte
| I have a customer looking to buy Quad 3C Feeders. | He is evaluting the possibility of either buying these | feeders or buying a whole Quad Pick and Place. | Qty: 30 8mm Feeders I do have a source of Quad III C and IV C machines with a total of 200
Electronics Forum | Thu Sep 21 14:15:09 EDT 2006 | lheiss
A list would be great. Thanks, Larry lheiss@speastech.com
Electronics Forum | Wed Sep 20 18:12:07 EDT 2006 | lheiss
I forgot to ask if anyone knows what numbers I should get for function 30, nozzle height and center of rotation? I'm getting 365 for height and 12314 for center of rotation. I know it isn't 12.314 inches out!
Electronics Forum | Thu Jun 03 20:15:23 EDT 2004 | Ken
My Machine guy was a 4 year ex-quad Service Engineer. Prior to that he spent 6 years in a CM programming and servicing quads from QX toQ3c/4c q100 series. These are opinions. Nothing more. I have noticed that the smallest players in the market
Electronics Forum | Wed Sep 20 10:05:10 EDT 2006 | SWAG
Not familiar with 3C/4C but if the head is similar design to Samsung then you might consider flushing the tubes and airlines that go to the nozzles. We used to disconnect the airlines at the top and run cleaner down through the tubes. We would then
Electronics Forum | Tue Sep 19 18:06:05 EDT 2006 | lheiss
Does anyone know of a source for better documentation for the laser align settings? I managed to get a 1206 ceramic capacitor to measure and was working on a 1206 resistor and couldn't get it to succeed. I retried the cap and it failed again and ag
Electronics Forum | Tue Sep 19 22:55:21 EDT 2006 | darby
Hi Larry, me again. Painting the tip should do diddly because you are using laser. Your cap is probably passing because it's thicker and is just inside the range of the system set-up. Check and calibrate your nozzle alignment height settings. Input t
Electronics Forum | Thu Sep 21 08:06:15 EDT 2006 | bobpan
I think 365 is ok. You should check and make sure the z-rod's spring is ok. Just make sure it is not sticking. Dont waste your money on the pm. If you want a complete list of things to do.....leave an e-mail address and i can e-mail you a list.
