Electronics Forum | Mon Apr 03 08:51:43 EDT 2017 | teslalab2
When you update a Quad to windows, they replace the epcu card with some other card, does anyone know the part number on that card? Thanks
Electronics Forum | Thu Oct 01 13:04:57 EDT 2015 | ahanna
ahanna@lumitex.com Thank you very much I appreciate it!
Electronics Forum | Mon Sep 28 09:58:45 EDT 2015 | ahanna
Hello everybody! I'm working with a Quad 4000c that has been refurbished by PPM and need a little help with using the CAD feature. Is there anyone that can help me out by giving me a basic walk through of how this works? I'm not sure if this is valu
Electronics Forum | Thu Oct 01 12:37:54 EDT 2015 | deanm
If you are still looking for information I have a procedure that our company used that I could send you that should still work for the 4000C. Please post your email address.
Electronics Forum | Fri Jan 03 15:16:54 EST 2014 | ppminc
If all of the lights are on, on the operator interface panel usually that means the EPCU is defective or not fully seated correctly. If you swapped out the EPCU board from another machine you need to make sure its the same type of machine. If it has
Electronics Forum | Fri Aug 30 11:31:29 EDT 2013 | nophsem
We have two QUAD 4C working in tandem. 3 months ago the EPCU battery (QUAD # 2) died, then we change it. Then downloaded the MODs from the controller to the assembler(does simultaneously on both machines). All this time we continue to work normally.
Electronics Forum | Thu Jan 07 15:48:03 EST 2016 | ahanna
Hey everybody! So my Quad 4000c has been acting funny lately. When it goes to dumb a rejected part into the dump bucket it doesn't actually drop the component. This results in it trying to pick up another part with the previous part still on the nozz
Electronics Forum | Mon May 16 19:57:51 EDT 2016 | rx8pilot
I recently purchased some used ThinPRO precision feeders for my Quad IV-C (PPM 4000C). They are in great shape, but I do not know how to program them to index at 2mm Does anyone have experience with these that know how to program them? I can only go
Electronics Forum | Thu May 26 09:21:37 EDT 2016 | bobpan
Everytime I have seen an offset like that it was dirt on the quad-align lens.....try cleaning it off with alcohol and a lint free cloth. If this does not fix it....you may have dirt inside the quad align itself. I am assuming you have checked to ma
Electronics Forum | Thu Dec 24 14:52:24 EST 2020 | bobpan
Good job, For the comm errors i would try: 1. Reseat all the cables that plug into the white multiplexer that is attached to the back of the computer. 2. Reseat the EPCU card down inside the machine. good luck, Merry Xmas, Bob
winsouce.jpg)