Electronics Forum | Mon Sep 30 15:26:48 EDT 2013 | leemeyer
I have been using Quad 4C's for 15 years and have never come across this error. Everything initializes OK but when I start a program through Central Controller I get an "OUT OF MEMORY" error. I have flushed the Mod codes and re-entered them and have
Electronics Forum | Tue Nov 08 07:23:03 EST 2011 | leemeyer
Thanks Bobpan, A function 6 tells me that I have firmware ver IVC 3.05. I keep getting a motor error 4 "The Xand/or Y axis did not reach the commanded position within 500 msec." The battery was dead on this machine so the mod codes were lost. I en
Electronics Forum | Mon Nov 07 13:52:10 EST 2011 | leemeyer
Can anyone supply me with the default MOD codes for a Quad 2C. I have recently picked up a used one and am having trouble getting to run properly. All I have is codes for a 4C. Thanks
Electronics Forum | Thu Mar 15 17:34:38 EST 2001 | rentreo
I place 0302's on my Quad 4c's all the time. Use a repeat pick-up just like a waffle tray part but make sure the z height is perfect on your pick-up or you will bounce the other parts out of their pockets. Also change your mod code to only try once o
Electronics Forum | Wed Jun 01 11:02:57 EDT 2016 | claudea2
I have 3 used Quad 4Cs and the nozzle changer on one machine never worked. I decided to troubleshoot it this week. I repaired the changer by changing a defective optical sensor but I still get error 17 when I try a run-step nozzle 1, 2 or 3. Error 17
Electronics Forum | Wed Jun 05 05:10:10 EDT 2013 | rollon65
Hi all. I already have a pair of Quad 4C Mk2 and purchased a Quad 4C Mk2 CE model secondhand. Some of the machine powers up but not the motor PCBs so the start up sequence stops after the nozzle changer operates with Motor Error #5 on the handheld.
Electronics Forum | Fri Sep 06 10:27:42 EDT 2013 | nophsem
Hi bobpan! MOD CODE 69 is "Waffle Tray Handler Installed Flag" and default setting 0. That's what mode code quick reference table says (the reference table that I've to respect according to the previous owner). And it's different what manual says (M
Electronics Forum | Thu Sep 26 10:04:46 EDT 2013 | nophsem
I tested original 'bad' SRX card in the other machine and it doesn't work, same error: SRX Autobaud Motor error #5 With our QUAD 4C, (Machine speed setting) MC 53= 0 (high speed), I changed =1 (low speed), same error
Electronics Forum | Fri Sep 06 11:37:43 EDT 2013 | bobpan
I dont have a list for anything that old. The oldest i have is version 2.10. Check to see if the mod code list that you have says what version it is.....usually its on the top of the document
Electronics Forum | Fri Sep 06 11:07:27 EDT 2013 | bobpan
Use the hht and do a function 6.....this will tell you the version of firmware that the machine is running and then you will know which mod code list to go from. good luck