Electronics Forum | Tue Oct 01 11:56:57 EDT 2013 | bobpan
I would try the following: 1. Back up your mod codes or make sure they are up to date. 2. Turn off the machine and slide a business card between the battery and the clip located on the EPCU card in the front card rack. 3. Download back in your mod co
Electronics Forum | Tue Mar 10 17:26:35 EST 1998 | Jeremy Smith
Looks like it's more operator error that anything. I have 3 Qsp2's and a 4c. With exception of some software bugs they have been grate
Electronics Forum | Fri Nov 18 08:35:20 EST 2011 | bobpan
try this..... I think there is a coupling for the theta motor....make sure both set screws are tight.....maybe the theta is slipping. Make sure there are no bright lights shining into the machine....maybe even throw a dark cover over the top and try
Electronics Forum | Mon Nov 21 14:22:22 EST 2011 | mosborne1
Tim, The main controller card has a battery on it. Power down the machine and disconnect power. Stick a credit card between the battery and the clip. Hold for at least 60 seconds. Then power back up the machine. Make sure to have yourmod codes writ
Electronics Forum | Fri Sep 06 12:34:00 EDT 2013 | bobpan
Your firmware is so old that the problem is not in the mod codes anyways. You have a problem with the cyberoptics head. If its not working at all, i would remove the lens assy on the front side where the cable plugs in and blow out the unit. Maybe if
Electronics Forum | Tue Nov 08 15:07:51 EST 2011 | gosswald
I have been in the process of setting up a Quad 2C that lost its mod codes myself. Have you cleaned the glass encoder strips for X and Y? I was getting alot of motor errors until I cleaned them and I believe it was the error 4. Hope this helps.
Electronics Forum | Wed Sep 20 10:05:10 EDT 2006 | SWAG
Not familiar with 3C/4C but if the head is similar design to Samsung then you might consider flushing the tubes and airlines that go to the nozzles. We used to disconnect the airlines at the top and run cleaner down through the tubes. We would then
Electronics Forum | Thu May 26 14:06:03 EDT 2016 | stevedc
I did clean both lenses from the outside and checked all the MOD codes. I even removed the battery to reset everything and re-programmed all the codes but to no avail. I will strip it down and fully clean it to see if that helps. Just strange that
Electronics Forum | Fri Feb 01 19:12:18 EST 2013 | marcelorotofrance
Hi, I have a QUAD 4C mk2. I taught pickups and places from HHT. If I test them individually (RUN STEP PICK/PLACE etc...) before building the sequence, everything runs ok. After the sequence was built, everything goes wrong. Every PICK or PLACE ends i
Electronics Forum | Fri Sep 06 02:34:37 EDT 2013 | rollon65
Hi Marcelo The two machines I mentioned are the American type but they have an internal transformer fitted to convert from 110 to 220 Volts for U.K. Incidentally only one of the machines does it on a regular basis whilst the other one is mostly O.K
.gif)
