Electronics Forum | Fri Mar 04 19:38:44 EST 2011 | olddog
We are a very small (2 people) company and have recently purchased a used Quad 4c Mk II, for our low-volume in-house production. The machine appears to work perfectly for our needs. My question is regarding programming from a concept standpoint. Our
Electronics Forum | Mon Mar 07 06:51:31 EST 2011 | mosborne1
Tim you can do your image repeat after you place the whole panel with nozzle #1. In your sequence step program place all with nozzle 1. You can then change to nozzle#2 then place the whole panel with nozzle number 2. This will be one nozzle change. I
Electronics Forum | Wed Apr 11 00:40:19 EDT 2012 | ngineer
I have a problem setting up the LAE on my Quad 4c. I set it up for 0805, and it seems to work, although it rejects a lot of parts, at least it places "most" of them. I tried setting up on a soic14, and could not get even one to pass. I believe I h
Electronics Forum | Mon Jun 17 06:56:50 EDT 2013 | bobpan
Did you teach the reject mark? Sounds like a lighting issue when looking for the white sticker. You can also skip images by pressing control-repeat after the machine has found fiducials. Good luck
Electronics Forum | Wed Jun 19 07:24:10 EDT 2013 | bobpan
Hello Rollon, There needs to be a contrast between the sticker and board. The manual gives and example of a round red sticker. If you still cant still make this work.....Do the following. Run the machine and after it finds fiducials press stop on the
Electronics Forum | Tue Mar 13 13:10:09 EST 2001 | onset
As long as you perform a repeat pickup on the part with an ordinary feeder you will be fine.
Electronics Forum | Thu Mar 15 17:34:38 EST 2001 | rentreo
I place 0302's on my Quad 4c's all the time. Use a repeat pick-up just like a waffle tray part but make sure the z height is perfect on your pick-up or you will bounce the other parts out of their pockets. Also change your mod code to only try once o
Electronics Forum | Tue Mar 13 12:15:14 EST 2001 | onset
We have a 4C and it places 0402 components without any problems. The tricky part is getting the machine to pick them up out of the feeder it takes patience but you will get it. jake p.s. you
Electronics Forum | Tue Jan 11 13:28:14 EST 2011 | jmw
0603 and up should be no problem on the machine. If you are doing under 25 mil pitch the machine needs an upward camera to repeatably place the parts. You will always lose the first 10 or so parts with cut tape but that should be about it. Repair par
Electronics Forum | Wed Nov 16 05:12:36 EST 2011 | bobpan
A couple of things i would try: 1. Does function 30 give you a nozzle height that is repeatable. The number should be around 200.....+/- 20 or so. 2. I would change the z-rod because the spring could be worn out and when the vacuum turns on....it ca
.gif)
winsouce.jpg)
