Electronics Forum | Fri Mar 13 15:09:20 EDT 2015 | marcelorotofrance
Hello everybody Lately our machine has been working pretty well, but it can’t last too long. Now, during this week’s production cycle, it began to increase the component’s reject rate to alarming levels (obviously the operators reported me when the m
Electronics Forum | Fri Sep 24 14:05:06 EDT 2004 | jsloot
Is there anyone using a QUAD QSA-30? I am experiencing problems with the Y axis drifting in the positive direction. This can occur anytime from a few minutes to several hours after the problem has been fixed. Fixed means recreating a program from scr
Electronics Forum | Tue Nov 22 05:44:05 EST 2011 | bobpan
I thought the the machine was slowed down to speed setting 1 for the x/y axis and the machine worked. I think the x-motor was on its way out.
Electronics Forum | Wed Nov 09 05:12:43 EST 2011 | bobpan
Motor error 4 is an error that is caused by the machine not reaching a position in a timely matter. Usually its in the x/y axis but also could be z. If you have cleared the mod codes (function 35 shift 7) the machine should home. Usually this problem
Electronics Forum | Tue May 10 09:45:53 EDT 2011 | veeckm
After changing mod codes 50,51 and 54,55 respectively on the HHT I will then goto ccconfig.sys file in the central controller software and manually enter in the new mod code values. I do not do any uploading/downloading of mod codes through database
Electronics Forum | Fri Feb 01 07:11:07 EST 2019 | bobpan
x and y are the same...just change switches. t and z are the same...just change switches. The voltages on the cards are different(x/y same--t/z same)....i do have a procedure somewhere that allows you to make an x/y card into a t/z card. good luck
Electronics Forum | Mon Apr 29 09:58:38 EDT 2002 | pjc
Machine Data Mydata MY9 machine weight: 1800kg placement repeatablilty @ 3 sig: 15 micron x-y axis drive mech: x combo belt rackπnion, y ball screw Siemens F5 machine weight: 1500kg placement accuracy @ 3 sig: 30 micron x-y axis drive mech: x belt
Electronics Forum | Mon Dec 28 12:34:50 EST 1998 | Jon Medernach
Inorder to pick up 0402's RELIABLY correction is required in X & Y axis. Their are Chip Shooter that do this, (KME Create, and Sanyo) You can also place at +/- .002" at 43K cph with a Chip Shooter Bulk feeding is also desirable. It is not only the
Electronics Forum | Thu Apr 17 16:55:32 EDT 2014 | bobpan
Hello, The only thing i can think of is the x&y ribbon cables. I know you said they are good but they could have an intermittent break. I would get a spare set and plug them in with the machine at a slow speed setting and see if it works as normal. A
1 |