Electronics Forum | Thu Sep 21 14:15:09 EDT 2006 | lheiss
A list would be great. Thanks, Larry lheiss@speastech.com
Electronics Forum | Wed Sep 20 18:12:07 EDT 2006 | lheiss
I forgot to ask if anyone knows what numbers I should get for function 30, nozzle height and center of rotation? I'm getting 365 for height and 12314 for center of rotation. I know it isn't 12.314 inches out!
Electronics Forum | Thu Mar 24 09:33:45 EDT 2011 | bobpan
An old quad 2C/4C with a workholder will probably fit all those numbers. 2Ft is pretty long though and that might be a little too long. Machine price range is about right. Programming is pretty easy. Good luck
Electronics Forum | Tue Sep 19 18:06:05 EDT 2006 | lheiss
Does anyone know of a source for better documentation for the laser align settings? I managed to get a 1206 ceramic capacitor to measure and was working on a 1206 resistor and couldn't get it to succeed. I retried the cap and it failed again and ag
Electronics Forum | Tue Sep 19 22:55:21 EDT 2006 | darby
Hi Larry, me again. Painting the tip should do diddly because you are using laser. Your cap is probably passing because it's thicker and is just inside the range of the system set-up. Check and calibrate your nozzle alignment height settings. Input t
Electronics Forum | Thu Sep 21 08:06:15 EDT 2006 | bobpan
I think 365 is ok. You should check and make sure the z-rod's spring is ok. Just make sure it is not sticking. Dont waste your money on the pm. If you want a complete list of things to do.....leave an e-mail address and i can e-mail you a list.
Electronics Forum | Wed Sep 20 10:05:10 EDT 2006 | SWAG
Not familiar with 3C/4C but if the head is similar design to Samsung then you might consider flushing the tubes and airlines that go to the nozzles. We used to disconnect the airlines at the top and run cleaner down through the tubes. We would then
Electronics Forum | Wed Sep 20 16:24:19 EDT 2006 | bobpan
Larry, I would suggest not changing mod-codes on a machine that you dont know very well and that should solve the damaged z-rod problem. What you should do is get someone into your company to train you on the basic's of operating the machine. The $22
Electronics Forum | Wed Sep 20 18:07:52 EDT 2006 | lheiss
It wasn't my idea to reset all the mod codes. I was just doing what the guy on the other end of the phone said. I'm working on straighting the Z-Rod now and have a new one on the way as well as a grease kit. I've only checked with one company on d
Electronics Forum | Thu Jun 03 20:15:23 EDT 2004 | Ken
My Machine guy was a 4 year ex-quad Service Engineer. Prior to that he spent 6 years in a CM programming and servicing quads from QX toQ3c/4c q100 series. These are opinions. Nothing more. I have noticed that the smallest players in the market
winsouce.jpg)