Electronics Forum | Wed Feb 23 15:34:27 EST 2005 | c.b
No i,m sure you would like to have that title, then you can be a couple!!!!
Electronics Forum | Wed Feb 23 15:19:49 EST 2005 | Dilbert
I don't work on quads but I can give you some things to look for... Each of the moving axis work off a motor that is controlled by a "drive". Some of these drives have a fault or error output that is connected to the motion controller. One of your
Electronics Forum | Mon Jun 13 16:23:09 EDT 2005 | michaelmcclay
Hi Bobpan, I don't need or want to do this, I have to! I am very interested in what can be done. Please send more info. Thanks, Mike.
Electronics Forum | Mon Feb 06 20:57:51 EST 2006 | bobpan
Mazin, Give me some more information as to what originally caused the problem, Was there an electrical storm, was someone programming when the problem happened, Did you start it up and it happened, etc...etc... The more information the BETTER i can h
Electronics Forum | Sat Dec 30 18:49:39 EST 2006 | A.S.
TRY TO REPROGRAM THE AXISES AND CHECK THE WIRES GOING TO THE E-STOP BUTTON THESE PROBLEMS CAN CUASE THESE ERROS TO KEEP COMING UP TRY THIS AND YOU MAY FIX YOUR PROBLEM
Electronics Forum | Fri May 27 16:27:12 EDT 2005 | michaelmcclay
I believe it read Quad 1000 on the machine ID label. The serial number of the machine is 9518-A-02. The operator changed some settings in the configuration file and I need to get that back to the original settings. Any help you can offer would be
Electronics Forum | Tue May 31 07:04:20 EDT 2005 | bobpan
Mike, There was a dipswitch that can be changed that will clear the machine settings and reset everything back to defaults. You will also lose your programs so backing up everything is a must. If you need and/or want to do this let me know and i will
Electronics Forum | Mon May 16 13:40:42 EDT 2005 | michaelmcclay
Hi C.B, I have been doing some repairs on a Quad 1000 and I am getting to know it better that I want to. My comapny is located in San Jose, CA and I can offer you on site support if you are in the area. I also had an operator "update" the configura
Electronics Forum | Wed Feb 23 15:07:58 EST 2005 | bobpan
Hello C.B. I am a former trainer/fse for that machine and still have a q1000 bible for fixing problems. I think the machine may need servo tuned to which there is a procedure that i would have to find. First thing to do though, is to drop the machine
Electronics Forum | Mon Jun 13 19:07:57 EDT 2005 | bobpan
Mike, Right down all the settings you have for your machine (this may take a while). Also back up the programs you want to save. Now....if i can remember correctly.....when looking into the black computer box from the back of the machine...in your bo
.gif)
winsouce.jpg)