Electronics Forum | Wed Nov 27 18:10:41 EST 2002 | andrewbrook
Quad4C's have their moments. If the price is right and you are aware of the machines limitations then you will be satisfied. The placement rate is slow, 1.2 seconds/chip. Don't buy any Quad if it has the CyberOptics Laser unit, the Quadalign unit is
Electronics Forum | Wed Nov 27 09:51:08 EST 2002 | Claude_Couture
I have worked with 4c's for two years. The feeders are "tinker toys" with a mechanism that slips, so the pick-up has to be adjusted several times as the reel is used, especially with 13" reels. The worm gear was plastic on the steel shaft of the moto
Electronics Forum | Fri Nov 29 08:36:07 EST 2002 | Jeff Park
They have there strong points and weak ones. I have worked with them for the last 5 years and have seen some flakey problems (Cables, feeders, encoders) that will cause you some down time but if you get a good price on a system it might be worth it.
Electronics Forum | Mon Nov 18 12:07:02 EST 2002 | smckee
It would have to be really CHEAP! I ran one a few years ago, had 3 4C's gained together. Always had problem with the software and it was a high maintenance machine. Never had such problems with Mydata, Phillips or Zevatech. Also, it seemed I alwa
Electronics Forum | Wed Jan 23 11:28:47 EST 2008 | tbkonrad
Help! Since last Friday i have been having issues with a Quad qsv-1, it all started with a quad align error, i found there to be a small quantity of grease covering the lenses on both quad align sensors. I wiped the grease off and then everything s
Electronics Forum | Tue May 31 07:04:20 EDT 2005 | bobpan
Mike, There was a dipswitch that can be changed that will clear the machine settings and reset everything back to defaults. You will also lose your programs so backing up everything is a must. If you need and/or want to do this let me know and i will
Electronics Forum | Fri May 27 16:27:12 EDT 2005 | michaelmcclay
I believe it read Quad 1000 on the machine ID label. The serial number of the machine is 9518-A-02. The operator changed some settings in the configuration file and I need to get that back to the original settings. Any help you can offer would be
Electronics Forum | Mon Oct 09 07:50:22 EDT 2006 | quad
We currently run two Quad IVC's (we are very pleased with them) and two Versatronics for simple small volume batch work. We now need an additional machine capable of placing components at least three times as quickly as a IVC. We don't do anything ve
Electronics Forum | Sat Jul 27 17:21:19 EDT 2013 | ericrr
A mistake happened at our company before I got there where a wrong value was used, so now we have to check it with someone else to make sure the old empty reel is the same value as the new full reel. Some months after I started, I decided to check t
Electronics Forum | Tue Feb 29 15:43:14 EST 2000 | jacob lacourse
Hello, I was looking for a few companies that make belt feeders for pic and place machines. This feeder will have to compatible with a quad machine. Thank you
winsouce.jpg)