Electronics Forum | Mon Mar 02 10:09:47 EST 2020 | abarrow
Update-Please disregard Hello, new to the forum and machine so please bear with me. I am looking to change the pitch index on 12 and 16mm cl feeders. Is there a setting that I am not seeing or is an intelligent feeder required for this. Thanks in adv
Electronics Forum | Wed Nov 27 18:10:41 EST 2002 | andrewbrook
Quad4C's have their moments. If the price is right and you are aware of the machines limitations then you will be satisfied. The placement rate is slow, 1.2 seconds/chip. Don't buy any Quad if it has the CyberOptics Laser unit, the Quadalign unit is
Electronics Forum | Wed Nov 27 09:51:08 EST 2002 | Claude_Couture
I have worked with 4c's for two years. The feeders are "tinker toys" with a mechanism that slips, so the pick-up has to be adjusted several times as the reel is used, especially with 13" reels. The worm gear was plastic on the steel shaft of the moto
Electronics Forum | Fri Nov 29 08:36:07 EST 2002 | Jeff Park
They have there strong points and weak ones. I have worked with them for the last 5 years and have seen some flakey problems (Cables, feeders, encoders) that will cause you some down time but if you get a good price on a system it might be worth it.
Electronics Forum | Mon Nov 18 12:07:02 EST 2002 | smckee
It would have to be really CHEAP! I ran one a few years ago, had 3 4C's gained together. Always had problem with the software and it was a high maintenance machine. Never had such problems with Mydata, Phillips or Zevatech. Also, it seemed I alwa
Electronics Forum | Thu Jun 12 11:04:48 EDT 2014 | bobpan
You could have a bad hard drive or the bios settings could be incorrect. We also need to find out what motherboard version you have. Please e-mail me for further help. Go to: www.precision-repairs.com and my e-mail address is on the site. Bob
Electronics Forum | Thu Oct 27 20:32:43 EDT 2022 | oxygensmd
Hello. - Pickup offset works on with or above 505 softwares. - Offset correction works on feeders but the ProDesk won't overwrite your current SetUp / feeder cart. You have to overwrite manually or make new SetUp in Job (using optimalization),
Electronics Forum | Mon Oct 24 13:17:18 EDT 2022 | micropak
I have successfully used "Offset" in pick position on a particular feeder/component on F3. My L/C is Linux 503.04 and SC software is probably 010 (RMOS). This 406, you are mentioning as Station software ? I believe you have to do it in feeder setup,
Electronics Forum | Wed Jan 23 14:26:52 EST 2008 | operator
I have seen the bad alignment error many times and never had to replace the head for it. It usually has something to do with the laser windows being dirty or cracked. Also it could be your profile settings. Make sure all of these things are perfect b
Electronics Forum | Wed Jan 23 11:28:47 EST 2008 | tbkonrad
Help! Since last Friday i have been having issues with a Quad qsv-1, it all started with a quad align error, i found there to be a small quantity of grease covering the lenses on both quad align sensors. I wiped the grease off and then everything s
