Electronics Forum | Wed Jan 23 11:28:47 EST 2008 | tbkonrad
Help! Since last Friday i have been having issues with a Quad qsv-1, it all started with a quad align error, i found there to be a small quantity of grease covering the lenses on both quad align sensors. I wiped the grease off and then everything s
Electronics Forum | Wed Jun 19 07:24:10 EDT 2013 | bobpan
Hello Rollon, There needs to be a contrast between the sticker and board. The manual gives and example of a round red sticker. If you still cant still make this work.....Do the following. Run the machine and after it finds fiducials press stop on the
Electronics Forum | Mon Jun 17 06:56:50 EDT 2013 | bobpan
Did you teach the reject mark? Sounds like a lighting issue when looking for the white sticker. You can also skip images by pressing control-repeat after the machine has found fiducials. Good luck
Electronics Forum | Tue Feb 28 12:23:36 EST 2012 | veeckm
It sounds to me like your using only the Global fiducial mode. If your running multiple images on one panel use image fiducials instead
Electronics Forum | Fri Jun 30 09:49:05 EDT 2006 | bobpan
Did they take you into the real time computer and check the display live image ....to actually see if the quad align is good or not???? What types of errors are you getting???? Can you do a machine- calibration- quadalign and get a good reading????
Electronics Forum | Sat Jan 19 22:42:16 EST 2013 | ngineer
Ok, I managed to figure it out, and this is simply for anyyone having this issue. The issue was that the selected board or board folder did not reside in the selected board directory. the answer was to hold LSHIFT at startup to skip the autoexec of
Electronics Forum | Mon Feb 08 15:54:22 EST 2021 | bobpan
I think in the machine configuration there is an option to use the vacuum or not. Its been a long time but i think you just just skip past the vac message if it pops up. Pust both left buttons at the same (under the display) time to get into the mach
Electronics Forum | Sun Jan 20 17:55:49 EST 2013 | ngineer
Mikej, I'm only running a single image, just want to correct for the slight variations in how the board seats in the transport. It's not more than a few mils off, but enough to cause an issue on fine pitch parts. I don't have any image fiducial
Electronics Forum | Thu Jul 25 15:18:18 EDT 2002 | stefwitt
You would have to tell us what machine brand you are using, as everyone has his own idea how to recognize X-outs. I find the auto-recognition very time consuming ( non-productive machine time ), unless the camera could recognize an image in one shot
Electronics Forum | Tue Oct 09 05:38:29 EDT 2018 | dfl
Hi, my Quad IV-c is showing a really dark image on the camera and its VERY difficult to see the components pads to make the adjusts. I already check the monitor brightness (at maximum and I can see the crosshair, so the monitor is good) and already
